资源列表
Make-a-temperature
- 一个非常实用的温湿度测量程序，有完整的原理图和仿真图，C语言编写-A very practical temperature and humidity measurement procedures, and have integrated principle chart and simulation diagram, written in C language
ARM9_TFT
- 此程序基于s3c2440微控制器编写的TFT夜晶程序-The program is based on s3c2440 micro controller TFT night program written crystal
an_rjj05b1168_m16c_flash(1)
- renesas flash bootloader
2.04_spi_fullduplex
- spi fullduplex stm32 example project.. open source... thanks-spi fullduplex stm32 example project.. open source... thanks...
DG128-EEPROM
- DG128读写EEPROM的程序，非常规则的代码示例-DG128 EEPROM read and write procedures, rules of the code examples are very
hid
- 此文件是百合电子工作室推出的USB开源项目：Easy USB 51 Programer的一部分。 Easy USB 51 Programer 是一个多功能的USB学习板（USB接口 芯片采用philips的pdiusbd12），通过此项目，您不仅可以学习到 USB HID设备类的开发（包括下位机固件驱动的编写和上位机应用 程序的编写），还可以学习UB的其它标准设类（如USB Mass Storage）及自定义的非标准设备类的开发。Easy U
ganggaopai
- 使用8051点亮LED灯的广告牌程序，有源码和仿真，为本人大学所做项目，经过测试很稳定-Use 8051 lit LED lamp of the billboard procedure, have the source code and the simulation, the university for my project, after testing is very stable
keypress
- 51系列单片机的按键程序，经测试完全无误，对初学者入门很有用，注释很清析-51 series microcontroller key program, tested completely correct, introduction is very useful for beginners, comments very clear analyse
STM32
- 用STM32做的正弦波发生器固件，直接烧写到STM32即可。-With STM32 do sine wave generator firmware
ARM9-uboot
- ARM9系列的UBOOT移植完全手册，从零开始到精通-ARM9 family UBOOT transplant completely manual to master from scratch
Harmonic-Analysis_-Lecture-Notes
- Harmonic Analysis - Lecture Notes
software_mixer_fixture
- stm32F103 cotex m3开发应用工程-stm32F103 cotex m3 application project