资源列表
a2f30f7e-b2c9-4252-bed5-611e650f55a4
- 自己编写的Ymodem 协议，包括C文件和头文件-I have written the Ymodem protocol, including the C and header files
anjiandeLEDxianshi
- 行列式键盘的显示程序，四位8段LED显示-Remapping some DMA trigger sources from TIM16 and TIM17, USART1, and ADC different DMA channels
dulishijianpan
- 独立式按键的显示程序，四位8段LED显示-This register is used for specific configurations on memory remap. Two bits are used to configure the type of memory accessible at address 0x0000 0000. These bits are used to select the physical remap by software and so, byp
led_liushui.mcp_0_backup
- LED的流水灯程序设计，LED数码管显示-This register is used for specific configurations on memory remap. Two bits are used to configure the type of memory accessible at address 0x0000 0000. These bits are used to select the physical remap by software and so, byp
paomadeng
- 跑马灯程序，可以连续的循环，不间断LED法官二极管显示-This register is used for specific configurations on memory remap. Two bits are used to configure the type of memory accessible at address 0x0000 0000. These bits are used to select the physical remap by software and
key_led
- 行列式键盘，四段8位LED显示，包括键盘扫描，分段显示-This register is used for specific configurations on memory remap. Two bits are used to configure the type of memory accessible at address 0x0000 0000. These bits are used to select the physical remap by software and
2007101523539581
- GPRS源码，网上找的， 希望对大家有用-GPRS source online to find the hope that useful! ! !
FM31xx
- RAMTRON FM31XX的读写范例，来自原厂技术支持工程师-RAMTRON FM31XX reading and writing sample from the original Technical Support Engineer
CAN
- 双CAN收发程序，使用STM32单片机进行CAN测试，在kile开发环境下编写-Dual CAN transceiver STM32 MCU CAN test, prepared in kile development environment
ARM
- 嵌入式系统基础知识，ARM技术概述， ARM的指令系统，ARM汇编语言程序设计，ARM Realview MDK集成开发环境， GPIO编程，ARM异常中断处理及编程，存储器接口-The basics of embedded systems, ARM technology overview of the ARM instruction set, ARM assembly language programming, the ARM RealView MDK integrated developme
USB
- U盘的使用,使用51单片机开发，基于CH450芯片-you can use it
pwm-avr
- ATmega16 pwm波形发生器 avr-The ATmega16 pwm waveform generator avr