资源列表
240128
- lpc2220 240128液晶操作源码含资料-lpc2220 240128 LCD operations with the information source
hongwai
- 使用单片机实现红外通信的功能--转载自其他网站-The use of infrared communications MCU features- reprinted from other sites
mp3
- MP3播放器原理图和代码-MP3 player schematics and code
UART
- 这里是UART总结，主要是 PHILIPS 公司所出品的芯片，里面包括所出品的UART 性能，利于在世纪应用中选型。-This is summed up UART, mainly produced PHILIPS chip companies, which include the production of UART performance, in favor of the application of selection of the century.
18b20
- DY580实验板上面的18b20温度传感器程序，精确到0.1摄氏度，支持零下温度。-DY580 board temperature sensor 18b20 above procedures, accurate to 0.1 degrees Celsius below zero temperature support.
soft
- amega8 实现的摸拟USB芯片的AVR程序-amega8 achieved simulation procedures USB chip AVR
can
- can总线的电磁兼容性的一个小论文，里面主要讨论了分支与主干长度问题，数据传送速度问题以及在远距离进行通讯时所对电磁干扰的一点建议-EMC can bus in a small paper, which mainly discussed the issue of branch and trunk length, data transmission speed, as well as in long-distance communication when on the electromagneti
CONTROL
- 一个自己画的电子膨胀阀的控制电路，电子膨胀阀就是一个四相八拍的步进电机，你想用的话看看就知道了-A painting of their own electronic expansion valve control circuit, electronic expansion valve is a four-phase eight-shot of the stepper motor, you want to know, then take a look at the
test
- 毕设时做的CAN总线通讯电路板原理图，已经经过实验验证了，配合刚才的源码，应该没问题的-Complete set when the CAN bus communication circuit board schematics, has been tested with just the source, it should be no problem
VI2C_ASM
- 虚拟I2C总线汇编程序软件包 I2C 软件包的底层子程序，使用前要定义好SCL和SDA。在标准80C51模式（12 Clock）下,对主频要求是不高于12MHz(1个机器周期1us)若Fosc>12MHz,则要增加相应的NOP指令数。在使用本软件包时，请在你的程序的未尾加入$INCLUDE (VI2C_ASM.ASM)即可。-Virtual I2C-bus assembler package I2C Subroutine the bottom of the package, use t
51TimerInit
- 51定时器初值自动计算软件 选择工作方式和晶振频率计算定时器初值-51 timer software automatically calculates the initial choice of working methods and crystal frequency calculation timer initial value
uart
- 51单片机普通I/O口，做串口用，可以和真的串口一样，设置发送和接收的波特率，和发送接收的模式-51 Singlechip general I/O port, serial port used to do, you can and really like the serial port, set up to send and receive baud rate, and send to receive mode