资源列表
AD_calibration
- AD修正算法，提高AD精度，亲测可以使用，给予2812-AD correction algorithm to improve the accuracy of AD, pro test can be used to give 2812
firstoderfilter_dis
- matlab实现一阶低通滤波器并离散化。有图，可以验证滤波效果。-matlab first order filter discrete
DC_Motor
- 基于DSPTMS320F2812的无刷电机转速控制驱动程序-The program of controlling the speed of BLDCM, based on DSP TMS320F2812
Example_F2802xSpi_FFDLB_int
- C2000与STM32 SPI通信程序，C2000接收STM32传送的数据，做卷积计算后将结果回传至STM32-C2000 and STM32 SPI communication procedures, C2000 STM32 receive data transmitted, the result will be calculated back to the STM32 convolution
APF_ip_iq
- APF拓扑使用两电平拓扑，电流内环使用PI，电压外环使用PI，效果良好。-APF topology using two level topology, the current inner loop using PI, the voltage of the outer loop using PI, the effect is good.
comm_mac
- 实现两块DSP板之间通信（通过MAC）功能模块，模块对外接口明确.-The communication between the two DSP boards (through the MAC) function module, the module external interface clear.
DSP--Mfile
- This code contains information about the DSP project. I hope to be useful
SPEECHX
- . The normalized least mean square is the most popular due to its simplicity. The stability of the basic NLMS is controlled by a fixed step size. This parameter also governs the rate of convergence, speed of tracking ability and the amount of steady-
SVPWM
- 这段代码是针对三相电压型逆变器提出的，输入直流电，通过三相全桥得到三相相位互差120度的正弦波电压，控制开关管使用的是SVPWM程序。-This code for 3-phase voltage type inverter is proposed, and the input dc, three phase is obtained by three-phase full bridge phase difference of 120 degrees each sine-wave voltage,
step_motor
- 基于TI公司的TMS320F28335的DSP来控制步进电机的程序。开发环境为CCS3.3。-Based on TI s TMS320F28335 the stepper motor program. Development environment for the CCS3.3.
VMD642_mem
- ＣＣＳ３.３ｌｏａｄ程序之后，硬件仿真运行检查内存是否有错误-After CCS3.3load programs, hardware simulation run to check memory for errors
TMS320X281x-DSP-CAN
- 基于CAN总线，实现DSP2812芯片的收发程序-Based on CAN bus, the DSP2812 chip transceiver procedures