资源列表
CC2430-2
- 让用户掌握CC2430 的按键应用这一常用人机交互方法，本次实用两个分别控制两个LED灯。-Button for the user to grasp the CC2430 application of this common human-computer interaction, this practical two control two LED lights.
love
- 单片机分开发板中8*8点阵显示“love”的一个爱心图案-MCU sub-development board 8* 8 dot matrix display " love" of a pattern of love
CC2430-3
- 这个实验中使用按键控制LED 或闪烁，或熄灭。-This experiment using the control button LED or flashing, or off.
CC2430-4
- 用定时器1 来改变小灯的状态，T1 每溢出两次，两个小灯闪烁一次，并且在停止闪烁后成闪烁前相反的状态。-Timer 1 to change the status of a small lamp, T1 overflow twice each, two small lights flash once, and stops flashing before flashing to the opposite state.
CC2430-5
- 用定时器2 来改变小灯的状态，T2 每发生一次中断小灯改变状态一次。-Timer 2 to change the status of a small lamp, T2 occurs once every interrupt lights change state once.
CC2430-6
- 用定时器3 来改变小灯的状态，T3 每发生200 次中断小灯改变状态一次。-To change the status of a small lamp timer T3 interrupt occurs 200 times small lights change state once.
smartcar
- 基于飞思卡尔单片机XS128开发的整车程序-Based on the the Freescale microcontroller XS128 development of vehicle program
sd
- SD卡读写与Proteus仿真-SD card reader with Proteus simulation
dianzhicheng
- 使用keil uvision编写的一个简单智能电子称程序，除了测量重量外，可以检测串口连接是否成功，可以判断物体是否超重。-A simple intelligent electronic use keil uvision write the said program, in addition to measuring the weight, you can detect the serial port connection is successful, you can determine whe
shumaguanshiz
- 使用定时器时钟数码管显示 可按键修改-Using the timer clock digital display can be keys to modify the
ssin
- 基于9B92下的波形发生程序，使用SPI控制AD9833产生任意频率的PWM。已编译执行过，可直接在板上运行-Based on the waveform 9B92 under SPI control AD9833 generate any frequency PWM. Compiled execution, can be directly run on the board
PWM_LED
- 此程序是利用PWM原理基于单片机控制LED灯实现水滴效果-This procedure is to use PWM principle is based on single-chip control LED light water droplets effect