资源列表
LPLD_TSL1401
- 使用拉普兰德函数库编写的mk60线性ccdtsl1401的spi采集协议 并可配合串口观察-Use the Lapland library written mk60 the linear ccdtsl1401 the the spi acquisition agreement and with the serial observation
LPLD_UCOS
- mk60ucos嵌入是系统移植 单片机位核心为arm7 函数库使用飞思卡尔官方函数库配合拉普兰德函数库-mk60ucos embedded system migration
51danpianji-100-ge-yuanma-chengxu
- 里面有很多有关51单片机的源码，原理图，等。很适合新手入门。-There are about 51 single-chip source code, schematics, and so on. Very suitable for beginners.
Arduino-UNO-RFID
- Arduino语法是建立在C/C++基础上的，其实也就是基础的c语法，arduino只不过是把相关的一些参数函数化了，让没有单片机基础的人也可以轻松上手-Arduino syntax in the C/C++ based on, in fact, is the basis of the c syntax, arduino just put some parameters related to function, so no microcontroller based people can eas
nrf905
- stc12系列单片机驱动nrf905原创程序。包括905寄存器配置测试spi通信程序和905无线收发通讯程序。-The stc12 series single-chip driver nrf905 original procedure. Including the 905 register configuration test spi communication program and 905 wireless transceiver communications program.
485duojitongxin
- stc单片机通过max485芯片做的多及通信程序，包括一个主机两个从机的程序-stc microcontroller through max485 chip do and communication procedures, including a host two slave program
10sdingshiqi
- stc单片机原创10秒定时器程序，没十秒钟切换一次小灯亮灭状态。-The stc MCU original 10-second timer program, not ten seconds to switch from a small-state lights off.
51GPS
- 51单片机与GPS模块c语言程序，从GPS模块中截取经纬度信息。-51 and GPS module c language program, the interception of latitude and longitude information from the GPS module.
GM8123
- 51单片机C语言程序，stc12系列单片机uart2加GM8123串口扩展芯片原创程序。-51 microcontroller C language program, stc12 Series MCU uart2 of plus GM8123 chip serial port expansion original program.
USB-Device
- lpc1752 usb例子程序，各种功能都有。-Lpc1752 usb example program, all sorts of function.
lpc1752-usb--exemple
- lpc1752 USB例子程序，各种功能都有，是学习LPC1752最好的例子程序。-Lpc1752 usb example program, all sorts of function.
lpc1752-usb--c-program-software
- lpc172 例子程序 是学usb 最好的资料，还有上位机程序。-Lpc172 example program is the best material to learn the usb, and PC program.