资源列表
project20
- 抢答器的两个按键一个是设置清除键一个是开始键,按照抢答流程,可以实现简易8路抢答功能 (哈工大单片机大作业内附proteus原理图)-Two keys Responder is to set a clear key is a start key, in accordance with the the Responder process can be simple 8-way Responder (HIT SCM operations included proteus schematic)
project24
- 单片机的定时器产生秒信号,控制十字路口的红、绿、黄灯交替点亮和熄灭,并且用4只LED数码管显示十字路口两个方向的剩余时间。要求能用按键设置两个方向的通行时间(绿、红灯点亮时间)和暂缓通行时间(黄灯点亮的时间)(哈工大单片机大作业内附proteus原理图)-The microcontroller timer generates a second signal to control the crossroads of red, green, the yellow alternately turned
project45
- 5个开关K1-K5(从上到下),分别对应正弦波、方波、三角波、梯形波、锯齿波,按一下其中一个开关,则选择出所要产生的波形。(哈工大单片机大作业内附proteus原理图)-5 switch K1-K5 (top to bottom), corresponding to the sine wave, square wave, triangle wave, trapezoidal wave, sawtooth, click one of the switch, and then select the
project48
- 单片机采用中断方式,对2路0-5V的模拟电压进行循环采集,采集的数据送LED交替显示,并存入内存。超过界限时指示灯闪烁。(哈工大单片机大作业内附proteus原理图)-Microcontroller interrupt loop acquisition of 2-way 0-5V analog voltage data collected to send the LED alternately displayed and stored in the memory. Indicator flash
dingshizhongduan
- 51单片机汇编实现定时中断,使用多个计时器和中断器-The 51 MCU compilation timer interrupt use more than one timer and interrupt controller
VB-AVR
- VB程序实现与AVR单片机的通讯,来控制单片机的IO。-VB communication with avr
LED
- stm32 arm7控制led灯,跑马灯实验程序-the stm32 control led, Marquee experimental program
led88
- 8*8矩阵原理,及其代码,有汇编,也有c的-8* 8 matrix theory, its code, compilation, also c
stm32-usart
- STM32F103RBt6的串口通讯例程,采用寄存器方式实现。-STM32F103RBt6 serial communication routines, achieved register.
51mcuad9850
- 基于51单片机和AD9850芯片的DDS程序,通过LCD1602显示频率波形,步进可调,已经硬件调试成功-51 microcontroller and AD9850 chip DDS program, through the the LCD1602 display frequency waveform, step adjustable, has hardware debugging
PID
- 单片机通过PWM输出供电,驱动3个串联电阻,其中50K是一个电位器,人为不断的旋动电位器,来模拟负载无规律的变化。 目标要求:100uF电容两端的电压不受负载的影响,即ADC读数要求稳定在100左右。 大概的输出电压mV = 5000mV * ADC读数 / 255 调整 P、I、D 这三个系数,还有调整间隔检测时间,即可调整负载电压的稳定度和皱纹度。 -单片机通过PWM输出供电,驱动3个串联电阻,其中50K是一个电位器,人为不断的旋动电位器,来模拟负载无规律的变化。 目标要
STC51-download
- STC51单片机 免断电下载程序 演示流水灯-The STC51 microcontroller, no-power-reset download, the program demonstrates led change
