资源列表
humiture
- 温湿度模块主要采集变电柜中温度、湿度等数据，使得断路器出头工作在要求的范围中。-Temperature and humidity module collection substation cabinet temperature, humidity, and other data, so that the circuit breaker is in his early work in the required range.
wireless
- 无线模块主要是采集断路器触头温度通过RF出送给数据采集卡。-Wireless module acquisition circuit breaker contact temperature via RF to the data acquisition card.
bonus
- 单片机温度、时钟、报警程序，可以完美准确的实现各种功能，单片机要用容量大一点的！-Microcontroller temperature, clock, alarm program, accurate and perfect a variety of functions, the microcontroller to use large capacity!
KY2PZ
- 基于PIC16F887 PWM IIC AD 1307时钟读取显示时间 EEPROM的读写存放数据 等功能的实现-PIC16F887 PWM IIC AD 1307 clock reads time EEPROM write stored data and functions to achieve
modbus
- 基于51单片机的modbus通信程序 包括收发-Based on 51 single-chip the modbus communication program including transceiver
1602yejing
- 通过标准程序在液晶LCD1602上动态显示字符。-LCD1602 LCD dynamic display characters through the standard procedure.
main
- 矩阵键盘简易计算器，按键值处理函数，返回扫键值以根据需要改变返回值-The matrix keyboard simple calculator key value processing function, return sweep keys needed to change the return value
LED
- 从红外接收头接收到信息反映到LED上,在LED上看到接受信息-From the infrared receiver received the information reflected on the LED, to see receive information on the LED
NRF24L01-unwire
- 使用stm32神舟4号开发板通过无线模块NFR24L01控制另一个模块动作-Use stm32 Shenzhou 4 development board through wireless module NFR24L01 control another module action
ad_da
- 1.通过本例程了解并掌握AD-DA转换芯片的基本原理和使用 * 2.了解掌握I2C总线接口的工作原理及一般编程方法。-Through this routine to understand and master the basic principles of the AD-DA conversion chip and use** 2. Understand the works of master I2C bus interface and general programmin
touch-delay-switch
- 智能触摸延时开关源程序 用STC89C52单片机P0口的高阻态输入功能，扫描接口电平。手指将VCC与I\O接口半连接，产生高电平信号。用单片机高低电平控制继电器以达到间接控制节能灯。用单片机的定时器中断定时一段时间。利用人眼视觉暂留现象显示楼层数-Smart touch delay switch source with STC89C52 microcontroller P0 port high-impedance input function, scan interface level. F
remote-toilet
- 基于Arduino的远程洗手间使用状态指示装置程序.-State indicating device program based on the Arduino the remote toilet.