资源列表
Stepper.c
- 单片机控制步进电机的速度调整，以及正反转调整！-SCM control to adjust the speed of the stepper motor, reversing adjustments!
51c
- 单片机电子密码锁源程序，供单片机开发和学习参考-单片机电子密码锁源程序
ID
- ID读卡器，供学习开发ID读卡器设计的程序言参考-ID读卡器
DS18B20
- 温度传感器DS18b20的最新驱动，供单片机学习开发参考使用-DS18b20
1621_C
- HT1621C芯片驱动LCD液晶屏的一个实例！-HT1621C chip drive an instance of LCD LCD screen!
16
- 单片机16键的电子琴的设计程序，为单片机爱好者参考-单片机 16键电子琴的驱动
24c02
- 24c02存储芯片的驱动，供单片机学习者参考，本人经常用的-24c02
testprogram
- 用发光二极管可测试最小系统单片机的焊接是否正确。如果焊接正确则p0，p1,p2.p3口的灯会闪烁-LEDs can be tested using the smallest single chip welding system is correct. If the weld is properly p0, p1, p2.p3 port LED will flash
am_dds
- 基于430的调幅信号源程序。利用430控制两路ad9851来产生载波信号和调制信号-Based on 430 AM signal source. Ad9851 by 430 to generate two-way control of the carrier signal and modulation signal
gdLCD
- 运用单片机实现发光二极管左右跑马灯。灯的公共端接高电平。限流电阻330左右-About the use of single chip LED Marquee. Termination of public high light. Limiting resistor of about 330
Config_MMC
- Config_MMC.bas - (BASCOM) file for including into main program-Config_MMC.bas - (BASCOM) file for including into main program
single
- pc计算机与单片机串口通信源程序 包含上位机和下位机的程序 -PC computer and single-chip microcomputer serial communication source program