资源列表
weighing-system
- 基于51的称重系统，山东省2004年电子设计竞赛，word格式，原理图和代码在里面，原理图不是很清晰-51 weighing systems, electronic design competition in 2004, Shandong Province, word format, schematic and code on the inside, the schematic is not very clear
02Timer
- 51单片机使用定时器中断实现的定时器，时间通过键盘进行设定，数码管显示，蜂鸣器报警。-51 single-chip timer interrupts to achieve the timer, the time set through the keyboard, digital display, buzzer alarm
01uart_test
- 51单片机简单串口通信的程序，不断发送“I get”，受到数据后led翻转。-51 SCM simple serial communication procedures, continues to send " I get" , by the data led flip.
PWM
- TI的MSP430G2553的PWM程序。希望和大家一起分享，也给我提出一点改进的建议。谢谢。-TI s MSP430G2553 PWM program. Hope and share with everyone, also give me a little put forward Suggestions for improvement. thank you
no1.LED_SHOW_CODE_AVR
- 本程序是AVR单片机：http://www.ipbb.cn/post/avr.html的LED灯闪烁的C语言程序，这个是每个初学者必须经历的实验噢！-This procedure is the AVR MCU: C language program http://www.ipbb.cn/post/avr.html the LED flashes, this is every beginner must go through experiment
no7.Key_jiajian_SMG_SHOW_CODE
- AVR单片机的按键控制数码管的加减显示，单片机教程：http://www.mcujc.com初学者的朋友们需要注意，数码管有共阳共阴之分的，必须注意啊！-AVR Microcontroller keys addition and subtraction to control digital tube display microcontroller tutorial: http://www.mcujc.com beginner friends need to pay attention, the
no8.INT0_jishuo_SHOW_code
- 基于AVR单片机的INT0中断计数C语言程序，单片机教程：http://www.mcujc.com，外部中断触发一次，然后就会加1显示。对AVR单片机不熟悉的朋友们可以参考一下！-Based on AVR Microcontroller INT0 interrupt count C language programming, microcontroller tutorial: http://www.mcujc.com external interrupt trigger time, then i
c8051f_usb_bootloader
- c8051F usb bootloader hid-c8051F usb bootloader hid
an44168_13
- host sourced serial programming
msp430f149-for-PWM
- msp430f149单片机产生pwm波控制2个电机转动的C程序-msp430f149 microcontroller generate pwm wave C program to control two motors rotating
CMAXQUSB_U1_S0104
- The Maxim Command Module (CMAXQUSB) receives commands from an IBM PC through USB to create
MSP430F149-TimerA-pwm
- MSP430F149 TimerA 输出pwm信号-The MSP430F149 TimerA output pwm signal