资源列表
i2c
- 单片机I2C接口通讯，可实现与从机之间的通信，包括发送接受函数，十六位数据传输函数，及其校验位。-Single-chip I2C interface communications, can be realized from the communication between the machine, including sending and receiving functions, 16-bit data transfer function, and its parity bit.
STM32F107-of-RT-Thread
- STM32F107的神州IV开发板的RT-Thread移植，程序验证完整，可以直接使用。-The STM32F107 of the Shenzhou IV development board of the RT-Thread transplantation, program verification is complete, can be used directly.
At25fs010
- Flash通信，块擦除，整片擦除flash及对flash的读写和使能函数功能，也是通过spi借口通讯。-Flash communication, block erase, full chip erase flash and the flash read and write, and enable function, but also by spi excuse communications.
tftlcddrive
- LPC214X驱动SMG240128A的源代码-LPC214X drive SMG240128A the source code
Calculator
- 简易计算器， 可以进行简单的数学计算得了哈哈哈 望大家下载啊-Simple calculator, which can perform simple mathematical calculations had I hope you download.
STM32_USB_SD-reader
- 基于STM32_USB_SD读卡器，在我开发板上实验通过，效果不错，-STM32_USB_SD reader, I have developed on-board experiments by good results,
8951-play-music-(simulation)
- 89s51播放音乐(带ISIS Schematic仿真文件)-89s51 play music (with the ISIS Schematic simulation files)
Radio-over-Fibre-Technology
- Radio-over-Fibre Technology for Broadband Wireless Communication Systems -The research in this thesis focussed on the feasibility of using both single-mode and multimode fibres to distribute high-frequency microwave signals to simplified remote
29ymIDCcpxt
- idc的一套测评系统，试过感觉不错，所以上传，大家共享。-idc set of evaluation system, tried to feel good, so upload and share.
task
- 本例利用温度传感器ds18b20来测量温度，并借助于lcd1602液晶显示来显示实时的温度，本人已在实验板上验证通过-This case the temperature sensor ds18b20 to measure the temperature by means of lcd1602 LCD display real-time temperature, I have been verified in the experiment board
wannianli
- 单片机万年历程序 基于I2c 总线 自己写的 绝对好用-Absolutely easy to use microcontroller calendar program is based on the I2c bus
test6
- 使用8155实现对并行接口的扩展。利用8155的PA口输入D1区KEY组各按键的状态信息，然后将该状态信息通过单片机的P1口输出到D1区LED组显示。-8155 to achieve an extension of the parallel interface. 8155 PA port input D1 zone KEY group key state information, and then the state information through the microcontroller