资源列表
EEpROM
- 单片机上利用IIC总线存储芯片24c04的驱动程序，能实现数据的读取与擦写。-The microcontroller on the IIC bus storage chip 24c04 driver can read and erase data.
02-
- 从左到右的流水灯显示!接口电路和仿真文件很到的。-From left to right the water light show! To the interface circuit and simulation files.
receive
- 用SONIX做的红外接收器。可学习用户码。经过硬件测试。-The SONIX do IR receiver. Can learn the user code. After the hardware test.
PowerControl
- 嵌入式arm7-LPC2210的开关电源控制程序-Embedded arm7-LPC2210 switch power control procedures
EscapingCorners
- 龙人宝贝避免死区程序，使用C语言编程，AVRstdio编译，配套龙人宝贝系列产品-The baby avoid dead zone program, using C language program, AVRstdio compiled, supporting the baby series products
EMGTest
- digital signal process,draw signal line and save the line history and add some filter instruction.
tst
- 风摆的程序，利用PID控制风摆的角度，使风摆控制在指定的角度-The wind of a program, using PID control the point of view of a wind, the wind in the point of view of a control specified
ADC0809-and-C51-program
- AD0809数模转换芯片与单片机的连接仿真电路，并且C51编程实现了其与单片机的联合调试仿真，可以作为一个功能模块使用-Simulation circuit of the AD0809 digital to analog conversion chip microcontroller connected, and the C51 programming to achieve joint debugging emulator with microcontroller can be used as
1602-4LINE
- atmega16 四线控制液晶屏 1602程序和proteus仿真文件-of atmega16 four-line control procedures and proteus simulation file
Bootloader-example
- 本程序简单的示范了AVR ATMEGA16的IAP应用，实现智能升级 Boot Loader XMODEM-CRC传输协议 CRC16校验-This procedure is simple demonstration of the AVR ATmega16 IAP applications, intelligent upgrade Boot Loader That XMODEM-CRC Transfer Protocol CRC16 checksum
power--and-sleep-
- 本程序简单的示范了如何令AVR ATMEGA16进入睡眠状态及唤醒 电源管理及睡眠模式的介绍 进入最低耗电的掉电模式 关闭各种模块 外部中断唤醒 -This procedure is simple demonstration how to make the AVR ATmega16 go to sleep and wake The introduction of power management and sleep mode Access to the most
timer.PWM.ICP
- 本程序简单的示范了如何使用ATMEGA16的定时器 AVR定时器的要点介绍 T0工作于CTC模式，输出1KHz/2KHz 50 占空比的方波 T1工作于快速PWM模式兼输入捕捉 T2工作于相位修正PWM模式，输出490Hz的8bit PWM波-This procedure is simple demonstration how to use the ATMEGA16 the timer To AVR timer points The T0 work in CTC mode