资源列表
how_to_read_datasheet
- tell you how to read datasheet
LPC2114_2124-03_cn
- LPC2114资料，PHILIPS 单片16/32 位微控制器－LPC2114/2124-LPC2114 information,PHILIPS single chip 16/32 microcontroller-LPC2114/2124
duoji
- 舵机控制调试程序，C语言版本-Steering gear control debugger, C language version! ! ! ! ! ! ! ! ! ! ! ! !
lunwen
- 电视机控制器方面的文章，很全面的介绍了控制的编程思路-TV controller in the article, very comprehensive introduction to the control of programming ideas
can
- 关于can总线的一些资料，有愿意学习现场总线的可以参考下-Some information on the can bus, there are willing to learn you can refer to the Fieldbus
eeprom_ver1.0
- 富士通单片机95F108的flash模拟eeprom的程序，经过串口输出的验证-Fujitsu 95F108 MCU eeprom in flash simulation of the procedure by going through serial output validation
24c64
- 24c64 读写程序,89s52在线通过-24c64 read and write
CH375-TEST
- 本程序使用单片机I/O口模拟并口于CH375进行通信，可以读出U盘的参数，并且可以把U盘当做存储器，读写任意的扇区-This procedure using the MCU I/O port simulation parallel port to communicate on the CH375, you can read U disk parameters, which can be as U disk memory, read and write arbitrary sector
2009713133032
- 步进电机-Stepper Motor
lCD-51seriesprogram
- 51单片机的P0.0/AD0－P0.7/AD7端口接数码管的a－h端，8位数码管的S1－S8通过74LS138译码器的Y0－Y7来控制选通每个数码管的位选端。AT89S51单片机的P1.0－P1.2控制74LS138的A，B，C端子。在8位数码管上从右向左循环显示“12345678”。能够比较平滑地看到拉幕的效果。-51 SCM P0.0/AD0-P0.7/AD7 port access digital tube a-h end of the 8-bit digital tube S1-S8 t
DS18B20
- 温度控制 DS18B20程序实现DS18B20的读写-Temperature control program to achieve DS18B20 read and write DS18B20
SIX
- 电子控制多路输入系统,控制多种系统输入控制-Electronically controlled multi-channel input system, control system input control of a variety of