资源列表
main
- 一款有8种闹钟设置的时钟，通过一段时间的使用，情况良好。适用于CC100B、CC100C-The one with 8 kinds of alarm clock is set, through the use of a period of time in good condition.
160128
- 在C8051F020上测试过，控制芯片为T6963-Tested on the C8051F020, the control chip T6963
anjiansaomiao
- 按键扫描程序，上电时, 点亮P00口LED，操作室注意结对引脚-Key scanner, operating room pay attention to the pin junction
19264
- 19264液晶驱动,使用keil开发，本人使用的是C8051F020-19264 LCD driver, using keil development, I am using a C8051F020
filter
- 采用MAX262实现的程控滤波器，里面有MAX162的驱动，还有160128的液晶驱动。采用C8051F020开发-Program-controlled filters using MAX262 to achieve, which have MAX162 driver, as well as 160,128 of the LCD driver. Using C8051F020 Development
18B20danpianji
- AT89S51单片机和18B20温度传感器实现实时检测并通过数码管显示温度-AT89S51 microcontroller and 18B20 temperature sensor for real-time detection and, through digital tube display temperature
24CXX
- I2C EEPROM 24C读写器源文件,一个读写程序-I2C EEPROM 24C reader the source file, a reading and writing program
Pont
- 基于时间触发嵌入式设计模式（8051）源码-Based on Time-Triggered Embedded Design Model (8051) Source
SY_OO7
- 数码管显示当前温度程序 适用于CC100C，若数码管上电后有残影，请将液晶显示器拔下后重新上电-Digital tube displays the current temperature procedure applies to CC100C, if the digital control power after stuttering, please unplug the LCD monitor and re-power
SY_002_2
- 数码管显示程序 显示87654321 采用中断扫描模式-LED display program displays 87654321 interrupt scan mode using
SY_003_1
- 串口通信 数码管显示发送和接受的数据 串口波特率96-Serial communication to send and receive digital tube display the data serial port baud rate 9600
89c51_read_sd
- SD文件系统驱动程序基于89c51,可以移植到其他芯片的文件系统-SD file system drivers are based on 89c51, can be transplanted to other chips, the file system