资源列表
TLC1543
- TLC1543十位AD转换芯片程序，检测已通过，简单易懂-TLC1543 10 AD conversion chip procedures, testing has been adopted, easy to understand
CLKSMG
- 数码管显示的实时电子时钟，已调试通过，简单易懂-LED display for real-time electronic clock, has been debugging through, easy to understand
juzhenjianpan
- 单片机矩阵键盘的测试程序，两种方法，可以通过程序理解矩阵键盘的原理-MCU matrix keyboard testing procedures, both methods, you can program understanding the principle of the keyboard matrix,
LEDT0jishu
- 用LED数码管显示计数器对T0的计数值，通过此程序，理解计数器计数原理和LED数码管的基本原理-Counter with LED digital tube display the count of the T0 value, through this process and understand the counter counting principles and the basic principles of LED digital tube
ADC0809
- 一个小程序，有关AD转换的,可以参考一下，对了解这方面很有帮助-a small programme, applying to AD data converter
DS1302
- DS1302-制作的电子时钟程序（汇编语言）-DS1302-produced electronic clock program (assembly language)
liushuideng
- 流水灯的显示，即从左到右的八个灯依次间隔20ms依次显示，给人视觉上流水灯的感觉-Water light show, that is, from left to right followed by the eight lamp 20ms interval is displayed in turn, gives a visual sense of light water
LEDFLASHSHOW
- 数码管扫描显示(C语言),测试已通过，简单易懂-Nixie tube scan shows (C language)
AT89S5xwatchdog
- AT89S5x看门狗程序(C语言)，已通过测试-AT89S5x watchdog program (C language), has been tested
smg
- 数码管的显示程序，八个数码管从右向左依次显示0，1，2 。。A，B,C,D,E,F-Digital tube display program, 8 digital tube display from right to left followed by 0,1,2. . A, B, C, D, E, F
cx
- 51单片机的外部中断1引脚接开关K1，外部中断引脚0接开关K0，P1.0～P1.7分别接八个发光二极管，开机后只有一个发光二极管从左到右每隔0.5秒循环移动点亮。 当K1电平产生电平跳变时，二极管的循环移动发光被停止，取而代之的是黄色二极管5秒间的闪烁，闪烁频率为0.5秒，5秒钟过后，八个发光二极管恢复到原来的循环发光状态。 当K0电平为低电平时，无论是二极管处于循环移动发光状态，还是处于黄色二极管的5秒间闪烁状态，都应被强制中止，取而代之的是红色二极管以0.25秒间隔持续闪烁，当K0电
RTC_TEMP_1602_SingleKey
- 具有闹钟和温度显示的万年历，闹钟时间和实时时间均可调，闹钟设定时间掉电可保存-permanent calendar with alarm clock and tempreture display.Both the real time and alarm time can be set up,the alarm time also can be saved while the power down.