资源列表
Sendingandreceivingtheserialport
- 串口的发送与接收程序，完成使用单片机的串口传输数据-Serial sending and receiving procedures, complete the serial data transmission using SCM
msp430forsound
- 利用ti公司的msp430149单片机实现的声音间隔测量的实现-Ti' s msp430149 MCU using the voices of interval measurement to achieve the realization of
msp430149forcar
- 利用ti公司的msp430149单片机实现的声音引导系统的车载程序-Ti' s msp430149 microcontroller using the voice guidance system to achieve on-board procedures
msp430andDS18B20and1602
- 利用ti公司的msp430单片机和DS18B20实现的温度测量程序-The use of ti' s msp430 microcontroller and DS18B20 to achieve the temperature measurement procedure
msp430-NEC-MMC-
- 利用ti公司的msp430单片机和NEC公司的MMC电机专用单片机实现的电机控制-The use of ti' s msp430 microcontroller and NEC' s dedicated MMC Electric Motor Control MCU
SST29SF040
- SST29SF040读写程序，包括块读，块写，字节读，写-SST29SF040 read and write procedures, including the block read, block write, byte read, write,
djs
- 按SW19独立按键，倒计时开始 倒计时期间 继电器吸合 按SW20键继电器断开 计时暂停 按板上单片机复位按键 计数值恢复为999 此计数初值 可在程序中修改。-Press SW19 independent button during the countdown to begin the countdown relay pull-off time by SW20 key relay suspended by the board microcontroller counts reset butto
wxlzigbee20
- 基于ZigBee/802.15.4 的CC2430/CC2431 的(精简版)协议栈全部C51 源代码，精简版ZigBee 协议栈全面支持ZigBee FFD RFD、ROUTER\COORD 和多种网络拓扑。-Based on ZigBee/802.15.4 of CC2430/CC2431 the (Starter Edition) protocol stack, all the C51 source code, Starter Edition full support for ZigBee
chuankou
- 单片机，做的是温度测量管理，超出温度值或低于温度值，报警。-温度测量
PROTEL
- Protel99se学习资料，非常的经典，大家想学习pcb的都看看，欢迎交流。-Protel99se——pcb
SAA7111
- SAA7111 Video Input Processor
test_comm
- 电源管理程序,采用DS1307模块。可以参考学习-Power management procedure for the DS1307 module. Can refer to learn