CDN加速镜像 | 设为首页 | 加入收藏夹
当前位置: 首页 源码下载 嵌入式/单片机编程

资源列表

« 1 2 ... .75 .76 .77 .78 .79 22680.81 .82 .83 .84 .85 ... 33646 »
  1. SendStr_c

    0下载:
  2. ARM 2103串口收发-ARM 2103 serial port transceiver
  3. 所属分类:SCM

    • 发布日期:2017-04-02
    • 文件大小:56.68kb
    • 提供者:miao
  1. EASYWEB

    0下载:
  2. arm7,lpc2378的web浏览器驱动源代码-arm7, lpc2378' s web browser-driven source code
  3. 所属分类:SCM

    • 发布日期:2017-04-03
    • 文件大小:33.24kb
    • 提供者:卢锐
  1. MSP430-Basic-experiment

    0下载:
  2. MSP430系列单片机的基础DEMO实验,配套以MSP430F449为核心的学习版硬件平台-MSP430 series microcontroller-based DEMO experiments, supporting the learning in order to MSP430F449 as the core version of the hardware platform
  3. 所属分类:SCM

    • 发布日期:2017-04-01
    • 文件大小:674.26kb
    • 提供者:gantian
  1. MSP430-IAR

    0下载:
  2. MSP430系列单片机例程,包括ADC操作,FLASH读写操作,LCD点阵操作,端口操作,Timer操作等-MSP430 series microcontroller routines, including the ADC operation, FLASH reads and writes, LCD dot-matrix operations, port operations, Timer operation, etc.
  3. 所属分类:SCM

    • 发布日期:2017-03-24
    • 文件大小:193.1kb
    • 提供者:gantian
  1. pic24_led

    0下载:
  2. 用一个端口控制数码管的段码线(A~G、DP),另外一个端口经过75452驱动后控制数码管的位选线,用动态扫描方法,在八个数码管上显示12345678。-With a port control segment digital tube-yard line (A ~ G, DP), another driver after a port 75452 through the digital control bits control the selection lines, with dynamic s
  3. 所属分类:SCM

    • 发布日期:2017-03-30
    • 文件大小:990byte
    • 提供者:高涵
  1. uart

    0下载:
  2. 通过RS-232通讯接口和PC机建立通讯。PC机侧使用“串口调试助手”等串口调试程序,单片机程序运行后,接收由PC机发来的数据“This is PC.”,并回应“This is PIC24FJ64GA006.”给PC机。-Through the RS-232 communication interface and PC-establish communications. PC-side use " serial debugging aids" and other serial
  3. 所属分类:SCM

    • 发布日期:2017-04-11
    • 文件大小:1.29kb
    • 提供者:高涵
  1. uart_v

    0下载:
  2. 单片机A/D接电位器,串行口接PC机,单片机每隔1秒将采集的电压经串行口送给PC机。-Single Chip A/D then potentiometers, serial port access PC, SCM will be collected at intervals of 1 second, the voltage through the serial port to give PC.
  3. 所属分类:SCM

    • 发布日期:2017-04-03
    • 文件大小:1007byte
    • 提供者:高涵
  1. i2c

    0下载:
  2. 向24C02写入数据;读出地址由8位拨动开关输入,拨动开关时,读出的数据显示在8个发光管(G6区)上。-Write data to the 24C02 read out the address from the 8-bit DIP switch input, toggle switch, the read out data show that in the eight light-emitting tubes (G6 district) on.
  3. 所属分类:SCM

    • 发布日期:2017-04-07
    • 文件大小:1.8kb
    • 提供者:高涵
  1. LOGOLAR

    0下载:
  2. It is not a pencil sharpener. it is a screwdriver but it cannot be a screwdriver. it must be a pencil sharpener
  3. 所属分类:SCM

    • 发布日期:2017-04-06
    • 文件大小:93.51kb
    • 提供者:xxxx
  1. i2c_Source_code_Scenario_Analysis(beta2)

    0下载:
  2. I2C Source code Scenario Analysis(I2C 情景代码分析)-I2C Source code Scenario Analysis(I2C Source code Scenario Analysis
  3. 所属分类:SCM

    • 发布日期:2017-04-25
    • 文件大小:459.59kb
    • 提供者:xieqg
  1. bjdjkz

    0下载:
  2. 由单片机P2口输出的脉冲信号来模拟4相线圈产生的电流,来控制步进电机,用4个LED亮灭的快慢来模拟电机的速度,用它们的亮灭顺序来模拟电机的相序和拍数。-P2 port output from the MCU to simulate the four-phase pulse signal generated by the coil current to control the stepper motor, with 4 LED light blinking speed to simulate th
  3. 所属分类:SCM

    • 发布日期:2017-03-31
    • 文件大小:4.63kb
    • 提供者:赖珍明
  1. delay

    0下载:
  2. 所属分类:SCM

    • 发布日期:2017-04-11
    • 文件大小:1.18kb
    • 提供者:王工
« 1 2 ... .75 .76 .77 .78 .79 22680.81 .82 .83 .84 .85 ... 33646 »
搜珍网 www.dssz.com