资源列表
ARM指令集(中文)
- arm开发资料，关于arm指令集。熟悉arm开发的好方法-arm development, information on arm instruction set. Familiar with the development arm of a good method
signal_cpu_sort
- Use the verilog language write a MIPS CPU code, and have additional instruction, for example: selection sort instruction. The code has contain combination circuit and sequenial circuit. CPU have contain ALU, ADD, ALU_CONTROL, DATA_MEMORY, INST_ME
grlib-eval-1.0.2a.tar
- The GRLIB IP Library is an integrated set of reusable IP cores, designed for system-on-chip (SOC) development. The IP cores are centered around the common on-chip bus, and use a coherent method for simulation and synthesis. The library is vendor inde
gui_6448
- ARM的640*480LCD液晶屏图形显示源代码-ARM 640 * 480LCD screen graphic display source code
Study ARM Step by Step
- 一步步教你如何学习ARM，从引导代码到应用编程。-a step by step teach you how to learn ARM, from guide to the application programming code.
FS2410_APP
- 优龙的ARM9 FS2410开发板原码，含大量测试程序！如LCD，TOUCH SCREEN，IIC，IIS，KEY，RTC，UART都有了。极有参考学习价值，推荐下载！-Long ARM9 FS2410-source development board, with a large number of test procedures! As LCD, TOUCH SCREEN, IIC, IIS, KEY, RTC, UART have everything. Most reference val
FS2410_BIOS_I
- 优龙 ARM9 FS2410开发板的BIOS源程序！-Long ARM9 FS2410 development board BIOS source!
FS2410-DEV-V6.0
- 优龙ARM 9 FS2410开发板的硬件电路图！很有学习价值-9 FS2410 development board hardware circuit! Very worth learning
44b0BIOS
- 44b0启动代码 本项目在ADS1.2下编译,在SDT2.51的ADW中调试。编译时，请将整个44b0xbios目录拷贝到c:\\下-44b0 boot code of the item under the ADS1.2 compiler, in the ADW SDT2.51 tuning. Compile time, I would be grateful if the entire 44b0xbios copy of the directory c : \\ under
ARM的ADC
- 使用AIN0和AIN1测量两路直流电压，并将结果通过UART0想PC机发送。-compute and the use of two-way con measuring DC voltage, the results through UART0 sent to PC.
ARM上spi实现
- 使用硬件SPI接口与74HC595连接，控制74HC595驱动8个LED流水灯显示。-use of hardware and Bit SPI interface connectivity, control Bit-eight LED lights indicate water.
stos++源代码+说明
- 标准c++,c和汇编实现，仅支持ARM7,目前还不支持DEBUG，下一版本将支持-standards c, c and compilation achieved only support ARM7, does not yet support DEBUG, the next version will support