资源列表
HX711模块原理图及电子称原理图
- 关于hx711的原理图及功能，对于初学者有帮助(About hx711 schematics and functions, for beginners to help)
design architecture
- 这个是关于embedded systems的设计的文档(these are docs about design of embedded systems)
led
- 可以控制灯光闪烁，制作感应灯，控制灯光强度(Control light flicker, induction lamp)
##pinlvji
- 单片机频率计 系统采用单片机+分频模块+整形模块+lcd1602液晶显示+按键设计而成。 频率的测量范围为1Hz—20MHz能测量各种周期信号，能测出正弦波、三角波或方波等波形的频率。通过LCD1602液晶显示屏显示检测到的即时频率数值(最多8位数，单位为Hz)(SCM frequency meter system uses single-chip + frequency module + plastic module +lcd1602 LCD + button design. The fr
stm32_三路互补PWM
- 实现带死区的三鹿互补pwm灵活实现对h桥的控制(Implementation of Sanlu complementary PWM with dead zone to control H bridge flexibly)
main
- 用DS18B20温度传感器检测室内温蒂，并通过串口发送至上位机(Use DS18B20 temperature sensor to detect indoor Wendy and send it to host computer through serial port.)
qca7000-master
- This package is an SPI/UART driver for the QCA7000 serial-to-powerline chip
pipelined_fft_64_128_256
- 用verilog实现64点，128点，256点的fft(64 points, 128 points, and 256 points FFT are implemented with Verilog)
ALIENTEK MINISTM32 实验14 待机唤醒实验
- 在stm32的低功耗模式中，待机模式可以实现系统的最低功耗，在这种模式下，只需要2uA左右的电流。(In the low power mode of STM32, standby mode can achieve the lowest power consumption of the system. In this mode, only 2uA current is needed.)
W25x系列Flash芯片驱动程序(STM32单片机的SPI调试通过)
- W25x系列Flash芯片驱动程序(STM32单片机的SPI调试通过)
TouchGFX_Demo2015_5_7_inch
- touchgfx 例程TouchGFX_Demo2015_5_7_inch(touchgfx TouchGFX_Demo2015_5_7_inch)
实验43 USB虚拟串口实验
- STM32开发板上利用自生的USB功能实现一个虚拟的串口(The STM32 development board realizes a virtual serial port by using the self generated USB function)