资源列表
dingshiqi
- 采用定时器/计数器T0对外部脉冲进行计数，每计数100个脉冲后，T0转为定时工作方式。定时1ms后，又转为计数方式，如此循环不止。假定MCS-51单片机的晶体振荡器的频率为6MHz，请使用方式1实现(A timer / counter T0 is used to count the external pulse. After counting 100 pulses, T0 turns to a timing operation. After timing 1ms, it turns to cou
fangshier
- 编写程序，要求使用T0，采用方式2定时，在P1.0输出周期为400μs，占空比为10:1的矩形脉冲。(The program requires the use of T0, 2 timing in mode, 400 s in the output period of P1.0, and a rectangular pulse with a space ratio of 10:1.)
yanshi5fenzhong
- 试编程采用软件延时的方法来延时5分钟。（系统时钟为6MHZ）(The trial programming uses a software delay method to delay 5 minutes. (system clock is 6MHZ))
liushuideng
- 用74ls164的并行输出端接8个发光二极管，利用它的串入并出的功能，把发光二极管从左到右轮流点亮一个灯，并反复循环。（即流水灯效果）(A parallel output terminal of 74LS164 is used to connect 8 light-emitting diodes. By using its function of string in and out, the LED can turn a lamp on from left to right and circul
juchibo
- 试编程应用DAC0832输出锯齿波如图所示，锯齿波的频率为1000HZ（即周期为1ms），系统晶振为12MHZ。(假设DAC0832的芯片地址为A000H)(As shown in the DAC0832 output sawtooth wave, the frequency of the sawtooth wave is 1000HZ (that is, the period is 1ms), and the system crystal oscillator is 12MHZ. (assum
r16_sdk使用说明.txt
- Allwinner R16 SDK Document
嵌入式C C++语言精华
- 嵌入式C语言是作为嵌入式Linux开发的基础语言，也是学习嵌入式的必备语言。常用到的包括数据类型、运算符与表达式、控制语句、数组、指针、函数等内容。(Embedded C language is used as the basic language of embedded Linux development, but also an essential language to learn embedded. Commonly used to include data types, operato
23. ADC NTC热敏电阻测量温度
- ntc，10k，15w4k，新手必备 亲测可用(Clear annotations can be used perfectly for the number of words)
buspirate.py.tar
- buspirate based scr ipt for programmer nrf24 devices
DHT11调试实验（亲测通过 串口显示数据）
- 温湿度传感器，sht11调试实验，串口显示数据。(Temperature and humidity sensor, SHT11 debugging experiment, serial port display data.)
12864
- STC单片机的0.96寸，OLED128*64驱动(STCmcu 0.96 OLED128*64 driver)
flyer
- DIY Quadcopter with function of aerial view base on STM32F4