资源列表
29.2OLED_模拟I2C模式
- OLED的STM32驱动代码 提供各种应用接口 测试通过(OLED STM32 driver code to provide a variety of application interface test through)
CMTS3212的设计及实现
- 嵌入式接入设备是数字化时代的一大主流产品，嵌入式软件则是数字化产品的核心。简要介绍了中嵌入式操作系统/012345 的引导过程和底层软件的设计，并给出了6+7 设备驱动程序的一个实例。(Embedded access device is a mainstream product in the digital era, and embedded software is the core of digital products. The boot process of embedded operat
PWM
- 8051实现PWM调LED，可分级亮度，频率为2KHz。(8051 to achieve PWM tune LED, scalable brightness, frequency of 2KHz.)
Sensor data processing
- 处理传感器数据的程序，例如测距传感器。去掉一个最大值，去掉一个最小值，然后8个数据取平均值。结果去除了部分噪声，减少了误差。(program that deals with sensor data, such as a range finder. Remove a maximum, remove a minimum, and then take the average of the 8 data. As a result, partial noise is removed and error i
beep
- 合泰单片机简易TM使用，产生方波用于驱动无源蜂鸣器(Holtek MCU simple TM use)
STC_EEPROM延长使用寿命的大数据记录C程序
- 在文档里面，有j经过验证的C程序，主要用于解释STC的单片机里面的eeprom的使用效率和延长寿命的程序。(In the document, there are proven C procedures, mainly used to explain the STC microcontroller EEPROM inside the use of efficiency and extend the life of the program.)
stc12_eeprom
- STC12系列单片机掉电存储程序，在官方的基础上优化(STC12 series single chip off electricity stored program)
drv_RF24L01
- RF24L01驱动，基于STM32 Cube生成的HAL库函数改写(RF24L01 driver, based on STM32 Cube generated HAL library function rewritten)
STM32+UCOS+GUI+RTC
- 基于STM32103 的ucosii 操作系统和GUI实现的RTC例程(STM32103 based uCOSII operating system and GUI implementation of the RTC routines)
32倒立摆源码
- 电子设计大赛倒立摆源码，用51单片机实现并已成功实现。(The code of National Undergraduate Electronic Design Contest.)
PWM
- 捕获PWM输入信号，针对外部信号的采样分析。将采集的信号经过stm32处理，得到比对捕获结果(pwm catchCapture the PWM input signal, in view of the external signal sampling analysis.The collected signal through stm32 processing, than capture results are obtained)
s7-200做modbus主站与杰曼仪表通讯程序
- s7-200做modbus主站与杰曼仪表通讯程序(S7-200 MODBUS master and Jermaine instrument communication program)