资源列表
BOOTH2
- verilog booh multiplier-booth
booth_multiplier.vhd
- 这个程序实现了定点整数补码一位乘法运算器-booth_multiplier
boot_check
- 启动代码用于系统启动,完成系统功能,实现开机检测-Startup code
BQ20Z75gasgaugedataflashreadprogram
- 智能电池BQ20Z75控制芯片DATA FLASH 读出程式；共读出电池配制数据0x700个数据BYTE(1792) 从0X00开始存入于AT24C256EEPROM存贮器中；-Smart Battery BQ20Z75 control chip DATA FLASH read out the program were prepared to read out the data 0x700 battery of data BYTE (1792) starting from the 0X00 d
bq76925
- msp430f21x2控制bq76925采样的例子程序-msp430f21x2 control the bq76925 sample example program
Branch-threshold-method
- 运用分支限界法解布线问题。Branch threshold methodwiring-Branch threshold methodwiring
breakINT0
- 演示89C52响应中断：没有中断时，4个LED灯以闪烁为主，响应中断后则以广告灯的形式显示。由于采用下降沿触发，所以对于中断有一次记忆功能。-Demo 89C52 to respond to interrupts: No interrupt when the four LED lights to flash the main, the response disruption Zeyi advertising in the form of light display. As a result of
bu-jin
- 步进电机程序，通过单片机控制，调试时间改变速率。-Stepper motor program, through MCU control, commissioning time to change the rate.
bujin51qudong
- 利用51单片机控制步进电机并显示当前转速-The use of 51 single-chip stepper motor control and display the current speed
bujindianji
- 步进电机程序 很适合初学者学习参考 简单实用-failed to translate
BUJINGDIANJI
- 步进电机控制源程序 程序通过I/O口P6驱动步进电机反转-Stepper motor control source code program through I/O port P6 stepper motor-driven inversion
bujinjianji
- 两相四线步进电机驱动原理和程序。里面有两种方法驱动电机-Two-phase four-wire stepper motor drive principle and procedures. Inside there are two ways to drive motor