资源列表
RTOSmeg16
- 可以在meg16 上运行的 RTOS ,,,方便大家移植代码-Meg16 can run at RTOS,,, U.S. transplant convenient code
65520764GPRSsch
- 完整的gprs原理图，可以供初学者参考，本人强力推荐-Gprs complete schematic diagram, you can reference for beginners, I strongly recommend
200663016121150
- dsp54x学习板原理图，非常全面的原理图-dsp54x
mult-switch
- AT89S51单片机的P1.0－P1.3接四个发光二极管L1－L4，P1.4－P1.7接了四个开关K1－K4，编程将开关的状态反映到发光二极管上。（开关闭合，对应的灯亮，开关断开，对应的灯灭）-AT89S51 MCU P1.0-P1.3 next four light-emitting diodes L1-L4, P1.4-P1.7 next four switches K1-K4, programming will reflect the status of switches on the l
UART
- 本程序实现USART通信，基于PIC16F877芯片开发的。里面一个是发送程序，一个是接受程序。-USART communication implementation of this procedure, based on the PIC16F877 chip development. Inside a procedure are sent, one is to accept the procedure.
slaa280
- 基于TI公司的低功耗单片机MSP430G439为MCU的心电采集，滤波及心率测定程度。用C语言编写。-Based on TI' s low-power single-chip MCU for MSP430G439 ECG acquisition, filtering and determination of the degree of heart rate. Using C language.
pic16f877_ccp_frequency
- 本程序实现基于pic16f877的CCP输入捕捉和频率测量功能。-This procedure based on the implementation of the CCP Input Capture PIC16F877 and frequency measurement capabilities.
solar
- 本程序实现两路数据采集，数据分析，发出控制命令控制步进电机运转，基于pic16f877开发的。-This procedure achieve two-way data collection, data analysis, issue control commands to control stepper motor operation, based on the PIC16F877 development.
slaa228
- 用C语言编写的基于低功耗单片机MSP430作为MCU的FIR滤波程序。-With C language-based MSP430 low-power single-chip MCU as the FIR filtering process.
slaa136a
- 基于低功耗单片机MSP430的实现超神波测量距离的程序。-Based on low-power single-chip implementation of the MSP430 ultra-god-wave distance measuring procedures.
Jennic_ZigBee_2007-6-7
- Jennic ZigBee中文开发资料.pdf-Jennic ZigBee development information in Chinese. Pdf