资源列表
MyProject
- 基于stm32 的示波器程序 实现信号峰峰值有效值和频率的测量-Stm32 based oscilloscope program to achieve peak RMS signal and frequency measurement
WindFarm
- PSCAD软件对风电场（包括风机）建模仿真例程-PSCAD modeling and simulation software routines for wind farms
AD9850-sweep-frequency
- 基于AD9850的扫频程序，并通过NOKIA5110显示当前的频率值。用keil 4编译。-Based on AD9850 sweep program and displays the current frequency by NOKIA5110 value. Compiled using keil 4.
pidsuanfa
- 基于PID算法控制的智能 温控系统的实现 摘要： 本文介绍了一种基于PID 算法控制且带PID参数自整定的智能温控系统。给出了系统各部分的实 现方法， 详细讲述了本设计巧妙的A/D转化和PID 参数自整定的原理及软件实现， 最后简要提及了本设计的 应用实践及其应用前景。-PID control algorithm based on the Intelligent Temperature Control System Abstract: This paper introduces
无线遥控开关
- 单片机学习，用单片机实现无线遥控开关，基于MCS51单片机-Single-chip learning, using single-chip wireless remote control switch, single-chip based on MCS51
AHU
- 空调系统AHU仿真模型 1)阀门模型 2)表冷器模型 3)加热器模型 4)加湿器模型 5)传感器模型-AHU simulation model of an air conditioning system) valve model 2) Table Cooling coil model 3) Heaters Model 4) Humidifier Models 5) sensor models
ltc1655
- 单片机16位LTC1655 DA驱动程序，已经过测试。-MCU 16-bit LTC1655 DA driver, has been tested.
keeloq C
- microchip公司的HCS300 KEELOQ解码程序 C语言源代码-microchip company HCS300 KEELOQ decoding program C language source code
SH79F32_Zero_Cross
- 中颖单片机过零检测实例SH79F32_Zero_Cro-Single chip zero-crossing detection in the temporal instance SH79F32_Zero_Cross
BirdDSMC
- 直接模拟蒙特卡罗方法的程序，包括二维和三维-Direct Simulation Monte Carlo procedures, including two and three dimensions
S3F9454
- 电磁炉原理图和源程序。电磁炉源码 三星单片机S3F9454-Induction cooker schematic and source code. Samsung SCM S3F9454 Cooker Source
MBI.5030
- 驱动MBI5030IC显示4096色素LED-4096 color LED display driver MBI5030IC