资源列表
AD_SOFT
- 用研华提供labview控件编写的模拟量电压输入采集系统-Advantech provides labview control with the analog voltage input writing acquisition system
L298N-STEP-MOTOR-4STEPS
- 4相步进电机 L298N C51 keil-4 phase stepper motor C51 keil L298N
IO_LED
- 1-IO输出-点亮1个LED灯方法1单片机IO口调用和控制办法，对初学者很有帮助-1-IO output- light up an LED light single-chip IO calls and control approach, useful for beginners
zhongduan
- STC89C52的终端使用例程，可以帮助你了解-End-use routines STC89C52
USB
- usb的驱动程序，喜欢的赶紧下载，过期不侯啊-attention please,download quickly
Pseudo-Random
- Pseudo Random Sequence Generator Code and Tutor
MC68HC908GP32IDK
- MC68HC908开发板的原理图(PROTEL)-MC68HC908 development board diagram (PROTEL)
AVR_Renew
- 本程序用于ATmega8不小心写错熔丝，而无法进行ISP下载时进行出厂设置恢复。接线请参考AVR单片机并行编程。-This procedure for ATmega8 fuse careless wrong, and can not be downloaded when ISP to restore the factory settings. Please refer to AVR single-chip wiring parallel programming.
单片机9
- 遥控小汽车的设计 可以有限速区和加速区 对他完全实现自动控制-remote control cars designed to be limited to the speed zones and accelerating the full realization of his control
spi_slav
- It is code for avr microcontroller in which microcontroller acts as a slave
123123
- ISD4004录音放音程序，C51单片机控制实现ISD4004的录音放音功能。-program for ISD4004,it can record and play out.
yaokong
- 直接烧好程序，拔掉J15的跳线帽，否则免启动模块会干扰。然后在电脑上打开本程序文件夹串口调试助手，设置波特率为1200，如果使用USB转串口，则要选择相应的串口端口，就可以看到结果的了；如果用串口的话，要连接好串口线，并选择COM1。-Direct burn a good program, unplug the J15 jumper cap otherwise would interfere with free startup module. Then turn on the computer