资源列表
ert
- 定时器产生1毫秒方波，方波的时长，可由定时器调。-1 millisecond timer generates a square wave, square wave length of time, the timer can be adjusted.
M25PX_64Mb_Device_Driver
- spi flash 驱动程序 c语言,官方发行版-spi flash c driver
Keystrokes-counter
- 这个是一个关于简单的单片机的按键次数计数器。-This is one of simple MCU keystrokes counter.
src
- 基于DS18B20的单片机程序，用于温度检测-DS18B20 procedures based on the single-chip
51stepper--drive-circuits--code
- 51单片机控制步进电机的方法，内含全部的源代码-51 chip stepper motor control method, containing all of the source code
6N137_BATTCharger
- 锂电电池充电电路和源代码。不带低电压检测-Lithium battery electric circuit and the source code. Non-low-voltage detection
any-fre
- 任意分频，小数分频，计数分频的源代码，直接使用的模块，，已经在开发中使用过的IP包-Any frequency, fractional frequency count divided by the source code
mage8_rx
- Frequency hopping spread spectrum receiver using si4432 and atmega8, 50 channels 20ms hop time
24C08
- 单片机读写AT24C08的C语言程序，亲测可用，稍加改动即可读写其他I2C总线器件-Microcontroller to read and write AT24C08 C-language program, the pro-test is available, a little modification to read and write to other I2C-bus device
51_asm_DHT11
- DHT11数字温湿度传感器的应用资料 51程序 包括官方说明书，51的汇编程序、c程序，应用在dofly的任意开发板上 硬件只需要接VCC、GND、信号线 共3根线-DHT11 digital temperature and humidity sensor applications program includes 51 official manual, 51 assembler, c program, application in dofly any development boa
NRF24L01-RED
- NRF24L01 无线传输模块 接收程序 测试通过 -NRF24L01 wireless transmission module receives the program tested
Tilt-sensor-chip-program
- 用单片机控制获取倾角传感器的数据，结合控制步进电机来实现控制-MCU control for tilt sensor data, combined with the control of the stepper motor to achieve control