资源列表
LED4
- 流水灯积水，实验调试通过的，学习单片机初学者理解代码- program code for 80c51
Boot-number-of-memory
- 单片机编写程序，每次开机都将次数加1 并存储到EEPROM。这样就能直观的看到机器的使用次数，用P1口 LED做为显示，次数大于256是将溢出，按复位模拟开机 或者直接通过开关开机 -Microcontroller programming, each boot will increase the number of 1 and stored to the EEPROM. So you can visually see the frequency of use of the machine,
buzzer_timer1_interrupt
- avr单片机的定时器使用范例，介绍avr单片机的使用，对蜂鸣器操作-avr
osd-font
- 基于CT908的OSD字体与OSD显示的编程软件（全）-CT908-based OSD displays the OSD font with the programming software (full)
ADC
- AD 采集电压LPC1768-AD convert program for LPC1768
dynamicscanning
- C52+PROTEUS 8 位 LED动态显示
BootRom_2
- BF533 内部BOOTROM代码（整个工程文件）-BF533 BOOTROM internal code (the whole project)
test2-3
- 本程序演示一个计数器的工作过程 用定时器定时0.1s,每0.1要计数器加1，并在数码管上显示，高位零不显示-This program demonstrates the working process of a counter from time to time with the timer 0.1s, plus one for every 0.1 to the counter, and digital tube display, high zero does not appear
fasongxianshi-(1)
- C51单片机串口通信发送显示的C语言源程序-C51 microcontroller serial communication to send the C language source code display
am
- am modulation by dsk6713
open_leftToRightLeds
- 解决在protues仿真流水灯时出现不亮的问题的方法, 就是不要直接连接二极管和电阻, 中间需要加些导线.-Solve the protues simulation to the problem of water occurs when light is not bright, is not directly connected to the diode and resistor, need to add some wires in the middle.
51101
- 5110液晶模块SPI方式12×12点阵汉字显示-5110 LCD Module SPI mode 12 × 12 dot matrix character display