资源列表
Lcd1602
- 基于51单片机编写的1602驱动程序，编写环境是keil C 4。基本上都是通用的程序。-Written in 1602 based on 51 single-chip driver, the preparation of the environment is keil C 4. Basically common procedures.
zhinengxiaoche
- 2014年山西省电赛智能车程序源码，利用步进电机完成固定路径的巡查-2014 Shanxi electric smart car race program source code, the use of a stepper motor to complete inspections of fixed path
INC
- 周立功单片机EASY——2200系列开发板，自己做的iar环境下的模板，不包含无用代码，均可用；-ZLG MCU EASY- 2200 Series development board, iar environment to do their own template, does not contain unwanted code, are available
Telephone-billing-programme
- 电话计费功能程序，VHDL语言编写，已测，无任何问题-Telephone billing function program, VHDL language, has been measured, without any problems
STC12c5608
- STC单片机读写ADS1110,iic读写，调试成功-STC microcontroller to read and write ADS1110，iic read and write, debug successful
Light-water
- 利用msp430单片机的定时器timeA定时产生中断，在中断中按顺序依次点亮led灯，结束后，再依次熄灭led灯。-Use msp430 microcontroller timer timeA timer generates an interrupt, the interrupt led lights lit in sequence, after the end, and then turn off led lights.
Commulti
- Casio dt900的multidrop通讯协议的程序demo.-Casio dt900 The multidrop communication protocol procedures for demo.
C8051F020
- c8051f本测试程序用来测试板上所以I/O连接状况 外接LED共阳数码管 实验时将跳线帽接至+3V-c8051f the test procedure used to test the board so the I/O status of external LED anode connected digital tube experiments, the jumper connected to+3 V
uCOSII_FAT_CF_src
- uCOSII_FAT_CF源代码 uCOSII_FAT_CF源代码-uCOSII_FAT_CF source code uCOSII_FAT_CF source code for uCOS II_FAT_CF source code
image_sensor
- Sensor驱动代码 OV7680 的 是我们做的尝试 双摄象头 不过容易出现一些小问题 要做稳定需要好好调试-one sensor driver based on MTK 6225 platform :#define OV7670 #ifndef HW_SCCB void SCCB_send_byte(kal_uint8 send_byte) { volatile signed char i volatile kal_uint32 j fo
CC1100-315MHz-433MHz-Design
- 基于STC的CC1100软件驱动，发送程序部分。-STC-based CC1100 software driver, send the program part.
1
- Verilog语言编写的电话计费器程序-Telephone billing program written in Verilog language!!!!!!!!!!!!!!!!!!! !!!!!!