资源列表
lcd44780
- 在51单片机下44780液晶显示块的编程实例。-Under 44,780 in the 51 single-chip LCD block programming examples.
wannianli
- 采用定时器T0,作简易的万年历的时钟，另外用T1扫描刷新数码管。-Use of timer T0, for simple calendar clock, another scan with T1 refresh digital control.
ICL7135c
- ICL7135c语言程序 要结合着ICL7135的手册时序来理解-ICL7135c ICL7135 language program in conjunction with the manual to understand the timing
gsm-dialer-1.3
- GSM 拨号器，可自动拨号，支持CID,4+2，来电显示，DTMF解码，各种信号音控制，有线和GSM自动切换-auto dial，CID and 4+2 mode，ring display，DTMF decode，signal control，and switch each other from GSM and PSTN.
[TEST23]SPI-74HC595-8V
- pic 学习例子 定义配置字，晶振类型：XT，关闭开门狗，禁止低电压编程-pic study 定义配置字，晶振类型：XT，关闭开门狗，禁止低电压编程
ADXL345
- 调试通过的adxl345加速度传感器代码，x，y，z三轴加速度结果通过rs232输出-a c code about aadxl345 acclerate,the x,y,z derections are outputed by rs232
stm32f103zeprotel99lib
- 基于protel下STM32F103ZE144脚LQFP单片机元件电路图PCB元件封装库-For protel99 STM32F103ZE 144Pin LQFP Library
IIC-PCF8591-arduino
- 这是将pcf8591AD/DA转换器运用在arduino的开发板上的程序里面包括了wire的库文件-It is used in the pcf8591AD/DA converter program arduino development board which includes wire library files
UART
- 本程序运用MSP430G2553来进行UART传输，已经调试成功-The procedures used for UART transport MSP430G2553 has been successful debugging
MCU
- 单片机的9个实验程序，主要是通过单片机的串口输出数据，方波波形，led灯点亮等-MCU 9 experimental procedure, mainly through the serial data output of MCU, square wave, LED lights etc..
slidingmo11
- 基于滑模观测器的永磁同步电机矢量控制SIMULINK仿真图-Permanent magnet synchronous motor vector control SIMULINK simulation map based on sliding mode observer
STM32-RA8875--7LCD
- STM32使用RA8875驱动7寸液晶 显示正常-STM32 RA8875 driver to use 7 inch liquid crystal display normal