资源列表
i2c_slave
- I2C slave主程序要配置好I2C总线接口(I2C引脚功能和I2C中断，并已使能I2C主模式)
MCS-51-Library
- ＭＣＳ－５１单片机实用子程序库,有许多比较成熟的子程序供开发51单片机的用户参考-MCS-51 single-chip utility subroutine library, has much more mature subprogram for the development of 51 single-chip user reference
TC0_PCPWM
- mega128定时器0的相位修正模式产生的PWM波形-mega128 Timer 0 PWM waveform patterns generated by the phase correction
3
- LCD显示各种采集信号及数据走势曲线，可用于监测平台开发！ -LCD display a variety of data acquisition and signal the trend curve can be used to monitor the platform!
38
- 51单片机开发、单相八拍步进电机控制 请在KEIL中调试-51 MCU development, single-phase eight-beat stepper motor to control the KEIL debug
I2CPro
- 此源码利用单片机模拟实现IIC总线通信，可以连接基于I2C的硬件调试 -use of this source SCM simulation IIC bus communication, based on the I2C can be connected to the hardware debugging
intelstrataflash
- intel strata flash插写程序，可用于embedded系统开发。-intel strata flash write interpolation procedures can be used for embedded systems development.
PWM-wave
- ATmega16定时器输出两路占空比可调的PWM方波-The ATmega16 timer output two-way adjustable PWM duty cycle square wave
spi
- avr spi 程序-avr spi program
linux_oos_adu1314_driver
- linux adu1314 oos driver .仿照I2c的驱动模型，写了L3的驱动来实现adu1314 录音和放音。-linux adu1314 oos driver. modeled on the I2c the driver model, write the L3 the drive to achieve adu1314 recording and playback.
单片机例程：花样跑马灯Proteus电路图及asm程序
- 单片机例程：花样跑马灯Proteus电路图及asm程序 软件环境： Proteus 7.0以上版本，Keil uvision3 联合调试 芯片：AT89C51 电路：51单片机外接8个Led，4个功能选择键，2个速度控制键 功能：4个功能选择键可以选择Led的四种显示效果（闪烁、移动、摆动、计数），2个速度控制键可以改变显示动画的速度（时间间隔100ms-1s调整） 特点：按键可随时按下，显示效果立即更新
Link_Boot
- TS101的连路口程序，基于visual DSP++环境开发。该程序时c语言程序。 -TS101 link crossing procedures, based on visual DSP++ environment for development. The program c language program.