资源列表
vme
- ad程序是用来调试的小程序，希望多指教。-ad procedure is used to debug the small procedures in the hope that more exhibitions.
dct
- 离散余弦变化程序和测试 老好了
par_fir
- FIR滤波器流水线结构代码，通过流水线结构与分布式算法的结合-Pipelined FIR filter structure code
VHDLSourceProgramofReadDAatasFromSRAM
- 从SRAM中读取数据并显示的VHDL源程序，了解串口通信的基本原理，了解VGA现实图像的方法和原理。-VHDL Sorce Program of Read Datas From SRAM
pinglu(0.1-25.5KHz)
- 这是用于测量另一个单片机发出的信号的频率，只是在低频的测量，-This is the one used to measure the frequency of SCM signals only in the low-frequency measurements,
32bitCLA
- a carry look ahead adder
LED
- DSP控制8个LED循环闪亮，DSP型号为TMS320DM642-DSP control 8 LED flashing cycle, DSP TMS320DM642 model
shift-register
- FPGA/CPLD 的verilog移位寄存器代码。-verilog shift register code.
2916_motor
- 通过2916芯片驱动双极四线步进电机,节拍为单双八拍,并能正反转,记忆位置.-Bipolar four wire stepper motor through the 2916 chip, the beat is single and double eight shot, and can be reversed, memory location.
keyboard-scan
- 简洁的4x4键盘扫描程序，可以任意扩展哦。-keyboard scan
monichuankou
- 将单片机IO口模拟为串口发送数据，51单片机可直接编译后使用（若出现错码可适当降低波特率）-The single-chip analog to serial IO port to send data, the microcontroller 51 can be directly compiled using (error code if there may be appropriate to reduce the baud rate)
stm32f10x_crc
- stm32程序初始化部分c语言部分源码，主要还是串口部分-some program of stm32