资源列表
1542
- TLC1542程序！！ TLC1542程序-TLC1542 procedures! ! TLC1542 procedures! ! TLC1542 procedures! !
1_3
- 在程序中调用软件延时程序的点灯程序，要求定义状态寄存器的各种参数。
deng
- 逐渐明逐渐亮的led控制程序，逐渐 明逐渐亮的led控制程序，
IIC.rar
- DSP 5509A IIC通讯程序 特点： 1. C寄存器操作，是最好的IIC通讯原理学习手段。完整掌握IIC通讯过程，比看那个狗屁CSL好多了。 2. 定义了宏操作，可以实现对“位”操纵，新手可以学习一下。 ,DSP 5509A IIC characteristics of the communication process: 1. C register operation, the IIC is the best means of communication principle st
com.c.tar
- 串口通信测试程序--可以用于嵌入式linux下串口通信，也可以用于x86下-Serial Communication Test Program- an embedded linux can be used under the serial communication, can also be used under x86
9851
- 使用AD9851和80C51F02x系列芯片产生正弦波信号，而且频率可调，-Using the AD9851 and 80C51F02x chips generate sine wave signals, and frequency adjustable
Reg592
- 这是一个can和51的代码 挺好的 可以参考-This is a can and 51 of the code can refer to quite good
DFT
- 求单点的DFT 以及求序列的DFT 可应用于信号处理等-Demand single-point DFT and DFT request sequences can be applied to signal processing
leddisplay
- * 本程序为数码管显示处理模块程序 * 入口参数的两个字节里分别放显示的内容， * 这两个字节内容从高到低分别对应8段LED的A－F及DP段 * 1对应亮，0对应暗- * This program is digital display processing module program * entry parameters were put in two bytes show the content * high to low content of the two byte
mymutex
- Attached code provides the implementation of mutexex in linux. Mutex is used to protect shared resources in C/C++ appllications. This code is written based on BSD to help other community members
STC10_11_15_EEOPROM
- STC各个系列的EEOPROM操作要求不尽相同， 而这一个头文件是针对STC10/11/15三个系列的EEOPROM操作。-STC series EEOPROM operating requirements of each vary, but the header files for STC10/11/15 three series EEOPROM operation.
sig_bus
- 完成进程间信号通信实例,在linux下的编程，vi编译器-Examples of signal communication between the completion of the process