资源列表
zhiliudianjikongzhi
- 直流电机简单控制的参考程序（电机正转，电机反转，调速控制）-Simple DC motor control reference program (motor forward, reverse the motor speed control)
lpc2132mydemo
- lpc2132演示程序,同样是\"基于硬件FIFO和缓冲队列的\"串口收发演示，-lpc2132 demo program, it is also a "hardware-based buffer FIFO Queue and the" serial transceivers demonstration
周立功LPC2200bootloader
- LPC2200 BOOTLOADER文件，可直接下载使用
DegreeControl
- 基于C51单片机的温度控制小程序，通过两路PWM输出控制一个水泥电阻的温度，用DS18B20完成温度的检测，LCD1602显示，里面有一个简单的闭环控制子程序，欢迎参考。-C51 microcontroller-based temperature control of small procedures, through the two PWM outputs to control a temperature of the cement resistor, complete with temper
C8051F020
- 全国海洋航行比赛智能航行C8051F020控制程序-C8051F020 Control Intelligent Sail
lpc2132_dome
- lpc2132演示程序,同样是基于硬件FIFO和缓冲队列的串口收发演示-lpc2132 demo program, also is based on the hardware and buffer queue FIFO serial transceiver demo
digital-clock
- 采用51单片机定时中断方式（T1方式2）设计，电子钟，显11-58-48秒，8位数码管。用汇编编写，带有仿真电路图-51 microcontroller using timer interrupt mode (T1 mode 2) design, electronic bell, which was 11-58-48 seconds, eight digital tube. Written in assembly with circuit simulation
LXD_led_phz
- 开发板6410环境中，用驱动程序对LED进行操作。-Development board 6410 environment, operated by the driver for the LED.
cap
- 本代码是基于STC89C52单片机最小系统开发环境的测量未知电容电路。根据555定时器的不同电容充放电时间得到未知电容值。-The code is based on the STC89C52 MCU minimum system development environment for the measurement of unknown capacitance circuit. According to the different capacitor charge and discharge t
Test_BatterySensor
- 基于JN5139这款SOC芯片的数据采集程序，利用GAINSJ开发套件上的温湿度传感器，将测得的温度，湿度值通过PC机的串口调试助手最终显示到PC机上。开发环境为Jennic CodeBlocks软件，使用C语言编写。-This SOC based on JN5139 chip data acquisition program, using GAINSJ development kit on the temperature and humidity sensors, the measured t
startdog
- Describe: Shenzhen Friends of the Kennedy Hengtian Technology Co., Ltd. S5PV210 development board WinCE6.0 the BSP source package, which DOC folder which contains all the documentation, can be above board in the development and smooth running up cost
cys_count
- A simple count-down LED timer that counts in minutes and seconds. Three buttons below the LED provide control of the unit, allowing you set the desired countdown time in minutes and seconds and a start/stop button. Completion of the countdown is in