资源列表
RS232控制灯闪烁程序
- 用C51语言开发，相当有趣，附详细文档及硬件电路图-with C51 language development, very interesting, with detailed documentation and hardware circuit
dspbios
- 有关dspbios的英文说明文件，里面包含代码和文字说明-English dspbios relevant documentation, which contains code and text descr iption
LED
- 基于嵌入式S3C2440的裸机点灯程序实现，程序在KEIL下实现。-S3C2440-based embedded bare metal lighting program, the program in KEIL implementation.
Minirisc
- 微型RISC处理器ip核，可以直接使用，包含详细的结构和端口介绍-Ip mini RISC processor core, can be used directly, contains a detailed descr iption of the structure and the port
GPIO
- 在dsp编程中，使用的通过输入输出口的配置。 很详细。-In dsp programming, using input and output through the mouth configuration. In great detail.
1602key
- 1602与键盘的小工程，对初学AVR的朋友很有帮助-1602 and key AVR
stc89c52_digital_tube
- 在stc89c52上的数码管程序，包括倒计时报警程序，精确时钟程序和数码管显示程序等。-In stc89c52 the digital control procedures, including procedures for the countdown alarm, precision clock procedures and digital display procedures.
gpio
- DSP编程，TMS320F2812芯片例程，GPIO翻转输出-DSP programming, TMS320F2812 chip routines, GPIO toggle output
51-MCU-Calculator-Code
- 基于51单片机的计算器DIY源码，内含C语言源码一份，汇编源码一份，完整工程文件-Based on 51 single-chip calculator DIY source, containing a C language source code, compile the source code of a complete project file
Use-CPLD--and-51MCU
- 用CPLD实现单片机与ISA总线接口的并行通信-Microcontroller with CPLD and ISA bus interface parallel communication
ucosii_data_AVRm8_icc
- UCOS在AVR单片机上的移植工程,开发环境为ICC.-UCOS in AVR on the transplant works, the development environment for the ICC.
RF2411_avr(RF2401EK)
- 用NRF2401实现无线收发，与51单片机连接的时候，需要加电阻。-The nRF2401A can be programmed using a simple 3-wire interface where the data rate is decided by the speed of the micro controller. By allowing the digital part of the application to run at low speed while maximi