资源列表
单片机入门程序
- 对于新手来说 研究这些例子 可以更快更好地学习51单片机.
Vxsam
- 石油设备采集数据板卡程序，vxworks的应用程序，值得参考。-Petroleum Equipment acquisition data card program
AVR_land_0513
- the ADC of atmega128l
nrf2401
- 2.4GHz无线数传模块nRF2401A驱动程序,SPI操作部分延时时间在11.0592MHz晶振下测试通过,等待发送时间根据与数据传输速率、数据宽度等参数相关,请参照器件文档.-2.4GHz wireless module nRF2401A driver, the SPI operation part of the delay time in the test 11.0592MHz crystal, waiting to be sent according to the data transf
rgbLED_control
- RGB灯控制程序，你可以了解如何实现不同色彩。-led red control,you can see the different kinds colours
7_4_Key_Long_Short_Moore
- WDT定时器设置为16ms中断。在WDT中断中，记录下最近两次的IO状态存在KEY_Now和KEY_Past中。根据前高后低可判断按键下，前低后高可判断按键松开，存入标志位Key_Dect中。 Key_Dect作为输入量，利用状态机函数Key_SM()，判断出短按键事件和长按键事件。分别调用各自事件处理函数进行处理。-WDT timer 16ms interrupt. In the WDT interrupt, the presence of KEY_Now and KEY_Past rec
Uart
- mega16单片机，串口调试源代码，调试成功，放心使用-mega16 microcontroller serial debugging source code, debugging success, ease of use
project_01_Booth_Algorithm
- Booth Algorithm 是一種較簡潔的有號數字相乘的方法，即利用位元掃描方式，跳過00、11以增快速度-Booth Algorithm is a relatively simple figure has multiplied its way, that is, using bit scan mode, skip to 00,11 by fast
elevator
- elevator simulator.is use to simulate process of elevators.
VC5509DSP-Timer-CODE
- VC5509DSP-DA-CADE,USED FOR timer C code,the code has been runn on the VC5509 ! no proplem-VC5509DSP-DA-CADE,USED FOR timer C code,the code has been runn on the VC5509 !no proplem
mimasuo
- 基于单片机的C语言电子密码锁，含proteus仿真图，AT24c02,LCD显示。-C language based on single chip electronic code lock, with proteus simulation map, AT24c02, LCD display.
deinterlace
- Xilinx提供的一种利用线缓存进行插值的隔行变逐行程序，比普通算法效果有很大改进。-Xilinx to provide a linear interpolation for the cache interlaced progressive change procedures, than ordinary algorithm results are greatly improved.