资源列表
test6
- 使用Grace编写的时钟类程序，主要是用于熟悉Grace的环境设置，利用Grace设置时钟模式。-Using Grace write clock procedures, is mainly used to familiar with the Grace environment settings, the use of Grace set clock mode.
TI_OEM_LM3S811
- 达盛LM3S811开发板专用测试程序，需要短接JP3,供测试板子性能用-Sheng LM3S811 development board up special testing procedures need to short the JP3, used for test board performance
ucos_FileSys
- 与嵌入式操作系统ucos配套应用，实现ucos下flash的文件系统
PIC_SPI_max6954
- 在MAPLAB开发环境下用PIC18系列单片机 IO口仿SPI读写MAX6954的程序，包括数码管显示输出和按键读取，都有测试程序。-Development environment in MAPLAB PIC18 MCU with SPI read and write MAX6954 IO port simulation procedures, including the digital display read out and buttons have testing procedures.
CONTROLV6.6
- 使用KEIL开发,房间监控系统,包括温湿度,大气压差传感器,液晶显示器,短距离无线数据传输模块-Use KEIL development, room monitoring system, including temperature, humidity, atmospheric pressure differential sensor, LCD display, short-range wireless data transmission module
5509A_Timer
- TMS320VC5509A&CCS3.3，内部timer程序，输出定时，输出信号可在XF检测，调试成功-TMS320VC5509A & CCS3.3, the procedures of internal timer, output timing, output signal available in the XF detection, the debugging of successful
_Principles_and_Applications_of_Higher_Education_R
- 高职_单片机原理与应用_教学改革的思考与探索-_ Principles and Applications of Higher Education Reform _ and Exploration
FPGA
- 从入门到精通FPGA，详细的介绍了GPGA的基本知识以及入门基础，是自学者不可多得的好资料-From entry to the master FPGA, a detailed descr iption of the basic knowledge and basic GPGA entry is a rare good information autodidact
parity
- i m working in develommepnet of circuit with VHDL langage . so i hope that i can fide help in this wap pag.
A
- 用AVR单片机编写的汽车测速程序，其中包含了仿真图形，已经调试通过。这是我的毕业设计。希望给大家做个参考吧，采用1602显示，可以精确到小数点后6位，这个程序也可以改为测转速或者测频率。-Prepared using single-chip automotive AVR velocimetry procedures, including graphics simulation, debugging has been through. This is my graduation project.
SSP_SPI_Master
- lpc2131 ssp主站底层驱动源代码，同时包含演示工程-lpc2131 ssp master low-level driver source code, demonstration projects that contain both
Code-Calculator
- 带计时功能的计算器。用C语言编写的，基于51单片机，用proteus作为仿真软件，实现计时与计算的双重功能。-Calculator with timing function. With the C language, based on 51 single-chip, using proteus as a simulation software to achieve the dual function of timing and calculation.