资源列表
252
- 基于uCOS-II的串口驱动(用Keil C)
duolutongxun
- 本同心采用Protues7.4对电路进行仿真，能实现各路之间的信息交流，系统出以良好状态-The concentric with Protues7.4 right circuit simulation, to achieve the exchange of information between separate ways, the system up to good condition
UCOS-II_core_6
- uCOS-II内核分析移植与驱动程序开发,书中的第6章源代码,极具参考价值,学完它可以很容易进行ucos系统上的应用程序开发.条理清晰易懂,最好配合书本一起看-uCOS-II core analysis of Transplantation and driver development, the book Chapter 6 source code, great reference value, study it can be easily finished for uCOS systems a
CC1110_CSMA
- 附件内文件功能是利用TI公司的CC1110单片机实现点对多点载波监听CSMA。程序在IAR7.2软件平台下编译通过，可以在CC1110单片机中正常下载运行。-Within the file attachment feature is the use of TI s CC1110 MCU-to-multipoint Carrier Sense CSMA. Under the program compiled by IAR7.2 software platform, you can download
VECTOR-0.0.1
- AD9958PCB 已经通过调试，可以直接产生多种波型。-Debug AD9958PCB has passed, you can directly produce a wide range of wave-type.
music-and-LCD
- 音乐与PWM数值的显示。在放音乐时，会有音乐声音发出，同时显示音频设置的数值。-music and The PWM ORC1A number appear.
123455
- 32位累加器，包括32位加法器与寄存器，程序与仿真文件包含在内，在相应的环境下可直接运行-32-bit accumulator, including 32-bit adder and register, procedures and simulation files included, can be run directly under the corresponding environment
lm3s1138SSI
- 这是我买的开发板中的配套程序，包括1位数码管的静态扫描和8位的动态扫描及SSI的相关介绍，程序我以测试过。-This is a development board I bought the matching procedures, including a digital control of static scanning and 8-bit dynamic scanning and SSI related to introduction, the program I tested.
1602_4bus
- 1602LCD,四位总线驱动，PIC16单片机，proteus仿真,MPLAB工程,HITECH-C编译器-1602LCD，four bus mode driver,PIC16F877A, simulate proteus
examples-of-51MCU
- 51单片机的100个开发实例，有源代码，注释很详细哦！-51 SCM 100 development examples, source code, very detailed notes, oh!
C8051-GSM
- 采用C8051单片机控制西门子TC35I GSM模块收发短信，拨打电话的源程序-C8051 MCU control Siemens TC35I GSM module send and receive SMS, call the source
LM35
- 基于LM35温度传感器的温控系统设计,硬件加软件设计，看看有用没有啊-LM35 temperature sensor based on temperature control system design