资源列表
fasong1.0
- 用单片机控制实现红外无线传输控制程序，已经过验证。-MCU control infrared wireless transmission control procedure has been verified.
2011072018573802
- 单片机万年历制作全部资料，基本上全了，当年的课程设计-SCM calendar produced all the information, basically the whole
RF2401_LPC2103
- LPC2103下的RF2401的驱动程序-a driver program about RF2401 based on LPC2103
MAIN
- 智能检测软件，ate相关设计-Intelligent detection software, ate-related design
ZLG_CF
- ZLG开发板上关于读写CF卡的代码，带有文件系统
file_verilog
- 该文件用在CPLD上的，和C语言很接近，5位的计数器一个。-the documents on the CPLD, and the C language is close to that of the five counters one.
SCM_C_Language_Learning_Notes
- 单片机C语言学习笔记SCM C Language Learning Notes-SCM C Language Learning Notes SCM C Language Learning Notes
USBPBootloader
- C8051F320的USB BootLoader我也是找了好久。上位机一定要写入PID与VID。我下到板子上用过了，能通过USB下载。-C8051F320' s USB BootLoader I am also looking for a long time. PC must be written to the PID and VID. I used the following to the board, through the USB download.
飞思卡尔电磁车程序
- 附件中包含飞思卡尔智能车比赛电磁车源代码，欢迎交流学习。(This rar file contains the electromagnetism car source code in FreeScale challenge.)
基于51单片机数码管+流水灯+计算器+矩阵键盘仿真
- 通过protues 仿真计算简单的运算功能并显示其结果，同时切换功能按键实现流水灯和数码管操作(The simple computing function is calculated and the results are displayed by Protues simulation. At the same time, the function keys are switched to realize the operation of the flow lamp and the digita
OLED显示例程
- 插上OLED屏，上电后通过OLED屏幕观察结果。 旋转编码轮可以看到OLED屏中间 Count 计数器的值进行+1或-1变化。 按下旋转编码器（OK键），可以切换OLED屏显示方向（正向或倒180度） 按下Cancel键，切换到白屏状态，方便检查屏幕是否有黑点。再按一下切换会主界面。(THE PRESENT FIRMWARE WHICH IS FOR GUIDANCE ONLY AIMS AT PROVIDING CUSTOMERS * WITH CODING INFORMAT
字库LCD12864液晶
- LCD12864带字库的PROTUCE仿真和程序(LCD12864 and PROTUCE simulator)