资源列表
ATA_Demo
- FS7805 使用ATA硬盘的demo
Ethernet_DM9161A
- LPC2300技术笔记例程 网络编程 DM9161-Routine network programming LPC2300 Technical Note
CAN-r
- can总线的发送程序，用c语言写的，基于飞思卡尔K60芯片，使用时需要修改相应管脚。-Transmission program can bus, with c language, based on the Freescale K60 chips, when used to modify the corresponding pin.
PIC18-C
- 这是PIC18的一些基本程序，对于初学者有一定参考价值！-This is some of the basic procedures of the PIC18, a certain reference value for the beginner!
mux_2to1
- 2选1的数据选择器 即当s＝1时，输出m＝y；当s＝0时，输出m＝x。 -Data selector 2-to-1 that is, when x = 1, the output m = y when s = 0, the output m = x.
I2C
- i2c for cortex m3 mcu
lab0309-Pwm
- 利用DSP F2812产生PWM波形用于晶闸管开通的控制，调试正确可以直接利用 -Generate PWM waveforms using DSP F2812 opened for thyristor control, debugging can use the correct
wnl
- 基于proteus仿真的单片机万年历实现程序-dssdffasdfas
TFT-STM32-128-160
- STM32的128*160液晶驱动及显示程序，能以各种颜色及字体显示汉字和字符，示例显示了普中科技带您进入单片机世界-STM32 128* 160 LCD drive and display program, able to display Chinese characters in a variety of colors and fonts and character, the example shows a general science and technology with the mi
ise
- 电阻应变式称重传感器噪声信号的分离Resistance strain gauge load cell separation of noise-Resistance strain gauge load cell separation of noise
NUC140VE3AN_MDK
- nuc140单片机KEIL MDK 工程例程-nuc140 microcontroller KEIL MDK engineering routines
飞思卡尔HCS12系列(计算器)程序源码
- 飞思卡尔HCS12系列(计算器)程序源码