资源列表
att
- ATMEGA48V单片机的电动车驱动系统设计 design of electric vehicle drive-ATMEGA48V MCU system design of electric vehicle drive
ARM_SC_UART
- LPC2129的时间触发方式系统设计，该系统运用静态路由表原理对TASK进行调度，相比于事件触发方式的系统更为可靠。-The LPC2129 time trigger mode system design, the system uses the principle of static routing table of TASK scheduling, the system is more reliable compared to the event trigger mode.
security-policy-roadmap-process-creating-security
- security policy and road map for security projet (cissp)
PIT
- 飞思卡尔128芯片 周期定时小程序 适合新人上手 -128 PIT
armASM
- ARM的汇编指令的祥尽解释，不过是E文版的，但看看大有好处。-ARM compilation directives do Cheung explained, but are E version, but take a look at a lot of good.
skyctl
- MCF51QE128CLK+ISL1208（IIC 总线）+串口时钟芯片程序，由串口打印出时间，有设置时间和读时间接口函数。IDE为Codewarrior。 -MCF51QE128CLK+ISL1208 (IIC bus) clock chip program serial print time, set the time and reading time interface.
CANPoints
- 摘要 总线上的节点是网络上的信息接收和发送站 智能节点能通过编程设置工作方式 地址 波 CAN ID 它主要由单片机和可编程的 通信控制器组成 本文介绍这类节点的硬件设计和软件设计 其中 特率等参数 CAN 软件设计包括 的初始化 发送和接收等应用中的最基本 SJA
FPGA
- 包括密勒码编解码、循环码编解码、FSK和PSK调制解调-Including Miller encoding and decoding, encoding and decoding cycle, FSK and PSK modulation and demodulation
99273873CANPoints
- The PCA82C250 is the interface between the CAN protocol controller and the physical bus. It is primarily intended for high-speed applications (up to 1 Mbaud) in cars. The device provides differential transmit capability to the bus and differe
pic-iic-example
- PIC单片机处于主模式和从模式的IIC通讯源码-PIC microcontroller is in master mode and slave mode IIC communication source
智能车程序
- 飞思卡尔智能小车
frequency-counter
- 利用AT89S51单片机的T0、T1的定时计数器功能，来完成对输入的信号进行频率计数，计数的频率结果通过8位动态数码管显示出来。要求能够对0－250KHZ的信号频率进行准确计数，计数误差不超过±1HZ。-AT89S51 microcontroller T0, T1 timing counter to the input signal frequency count, and count the frequency of results through eight dynamic digital