资源列表
LCD
- 这是一个基于飞思卡尔hcs12dg128的程序，主要完成通信，矩阵键盘和lcd1602的显示-This is a program based on freescale hcs12dg128, mainly to complete communication, matrix keyboard and lcd1602 display
ARM
- ARM资料库软件包，里面包含常用的一些工程模板，是开发更加简单-ARM library package, which contains a number of commonly used project templates, is to develop simpler
TempHumiPressSensor
- 温湿度传感器SHT75和气压传感器MS5534传感器的测量电路及嵌入式程序-SHT75 temperature and humidity sensor and barometric pressure sensor MS5534 sensor measurement circuits and embedded program
taximeter-in-verilog
- 本程序为出租车计价器的FPGA模拟功能实现，采用verilog语言编写。具体功能详见压缩包内的说明。-This procedure is for the taximeter FPGA simulation functions implemented using verilog language. You can see descr iption of the specific function in the rar package.
caisezhuanhuan
- 现色彩空间转换R’G’B’ to Y’CbCr的VHDL源代码。
The-temporal-logic-circuit-design
- 时序逻辑电路设计 实验内容 1．触发器（Ｄ型）； 2．计数器（递增、递减）。-Sequential logic circuit design, the contents of an experiment. Flip-flop (D type) 2. Counter (increasing, decreasing).
moniludeng-
- 路灯控制系统设计，有路灯故障检测和定时报警功能-Street light control system design, street light fault detection and timing alarm function
sht10-
- 基于温湿度传感器sht10的温湿度检测系统，实现了sht10采集现场温湿度信号，通过A/D转换器送至AT89C51单片机，对单片机编程实现在液晶显示屏显示温湿度，并设计了声光报警，由LED灯和蜂鸣器实现。-Detection system based on temperature and humidity, temperature and humidity sensors sht10, temperature and humidity signal sht10 collected at the
W27jlchongdianqi
- 这是一个关于12V的电瓶充电器的项目，里面有原理图，pCB还有程序，对想进行电瓶充电器开发的人，有很大的帮助。-This is a 12V to the battery charger on the project, which has schematics, pCB there are procedures, the battery charger to the development of people, very helpful.
16x64
- led显示，完整源程序 有需要的可以看看 仅供参考-led display, complete source code need to look at for reference only
the-measure-of-computer-capacity
- 单片机开发板实现的微机电容自动测量的小实验-Implemented by the microcontroller development board microcomputer the capacitance automatic measurement experiment
PC-to-more-than-one-MCU-LABVIEW
- PC与多台具有RS232接口的单片机开发板通信，每块开发板有不同地址。-MCU serial port communication