资源列表
STM32PUCOS-II=GPIO_PS2_TIM
- 1.板上的8 个按键分别 代表数字1-8，按下一个按键将结果通过串口发送到PC机上显示； 2.使用两个定时器模块，分别定时为1ms 和100ms 产生中断，使用它们分别 产生1s的定时时间，将时间分别显示到数码管上； 3.外接PS/2小键盘，将按键的值通过串口显示到PC机上。-A panel of eight key representing the number 1-8 press a key the results sent through the serial port on
Example_2803xEPwmDeadBand
- TMS28035的PWM口带死区设置应用例程，稍微修改后可直接应用于项目工程中，实用。(TMS28035 PWM port with dead zone settings, application routines, slightly modified, can be applied directly to project engineering, practical.)
上位机
- 下肢康复系统上位机控制，完成对于下肢来回运动的控制(A program to control lower limb rehabilitation system)
node-original
- 在RTOS51上移植了SI4463无线模块的通信协议(Transplanting the communication protocol of SI4463 wireless module on RTOS51)
mspfet_161014
- msp430单片机芯片程序读写程序~~ 强烈推荐下载，不可多得的430好工具！-msp430 single chip program to read and write procedures ~ ~ strongly recommend downloading a good tool for the rare 430!
light_telegraphic_code_four_frequency
- 实光电码盘的输出数据的四倍频，使码盘输出精度提高四倍。-real photoelectric encoder output data of the four frequency, accuracy encoder output increased by four times.
lpc21xx_Gpio
- lpc21xx系列的gpio接口demo程序，该程序包含了c和asm两种，都可以通过ads和jtag直接运行在lpc21xx的arm芯片中。-lpc21xx series gpio interface demo procedures, The program contains the c and asm2 two, can jtag through ads and direct operations in the arm lpc21xx chip.
serial_1.0-2_i386
- debian系统下的串口调试器，它是用c++开发，具有window下的串口调试器的所有功能。-Serial debian system debugger, it is c++ development, with a serial port under the window all the features of the debugger.
ha0098
- 利用holtek的HT49R50编写的热敏感应温度计的使用-use the HT49R50 prepared by the thermal sensor thermometer use
7TIM
- stm32单片机的开发例程，便于新手学习使用，最基础的代码-Stm32 development routines for beginners learning to use, the most basic code
MC33886
- 控制MC33886电机控制芯片的学习资料，用于智能小车的电机控制-Control MC33886 motor control chip learning materials for the smart car motor control
ucos2
- install ucos on floopy