资源列表
DDD
- 使用PE配置MC9S12G128MCU的实时时钟及AD端口配置为GPIO口使用-Real time clock and AD port configuration using the PE configuration of the MC9S12G128MCU for the GPIO port to use
AM2311
- AM2311程序,已在STM32F103调试通过-AM2311 u7A0B u5E8F, u5DF2 u5728STM32F103 u8C03 u8BD5 u901A u8FC7
5.1 超声波多路（调试通过）
- 基于STM32F103C8T6超声波多路电路，已调试通过(Based on STM32F103C8T6 ultrasonic multi-channel circuit, has been debugged)
ALIENTEK MINISTM32 实验2 按键实验
- 在STM32开发系统中，用按键实现对led灯的控制(In the STM32 development system, the button is used to control the LED light)
free_pendulum
- 149完美运行，误差1度左右。。。。。。。。。。。。。。。。。。。(149 perfect operation, the error is about 1 degrees)
SPI_8SEG
- 基于C语言的SPI通信程序，编写时基于DSP28335，也可用于单片机、嵌入式开发(SPI communication program based on C language, written based on DSP28335, can also be used for single chip microcomputer, embedded development)
4、继电器
- 51上的继电器设计，简洁干净，适合开发新的开发板(51, the relay design, simple and clean, suitable for the development of new development board)
F103_C++
- 这是一个用C++开发STM32的简易模板(A simple template for developing STM32 in C ++)
28035ecantest
- 28035CAN的单片机代码程序 ecantest(28035CAN cantest cantest dsp embeded system)
红外遥控直流电机教程
- 基于89C52单片机的红外遥控直流电机，及直流电机原理应用和程序详解(The infrared remote control DC motor based on 89C52 microcontroller and the principle and application of the DC motor are explained in detail.)
adc_soc
- ePWM1设置为在计数到比较寄存器值时产生SEQ1转换触发信号，ADC两通道ADCINA0和ADCINA1完成转换后产生中断，在中断子程序中分别提取ADC的采样值(The ePWM1 is set to generate the SEQ1 conversion trigger signal when the count to the register value is compared. The ADC two channel ADCINA0 and ADCINA1 complete the i
STM32驱动max6675测温的测试例程
- 通过使用stm32f103系统的单片机，通过程序，驱动max6675测量温度(By using the MCU of STM32F103 system, the MAX6675 can be driven to measure the temperature through the program)