资源列表
fifo_test.v.tar
- code for implementing high speed fifo for apturing data from fpga-code for for implementing high speed fifo for apturing data from fpga
kqln
- 当湿空气相对湿度大于1时，用该程序加载质量源项。-When moist air relative humidity is greater than 1, with the quality of the program loads the source term.
12864
- 带字库的串行12864调试程序 已通过本人测试 比较好用
基于s3c9454茶具泡茶定时器程序
- 基于s3c9454茶具泡茶定时器程序。S3F9454,FOSC=3.2MHZ .include "s3c9454.reg-Based on s3c9454 Tea tea timer program. S3F9454, FOSC = 3.2MHZ.include s3c9454.reg
key-display
- 单片机外围电路，扩展的4×4键盘液晶显示程序
UARTC
- UART Controller VHDL File
ds1302
- DS1302的驱动函数库函数，需要占用单片机的三个I/O口-DS1302 drive library function, the need to occupy the three single-chip I/O port
fuzzy_inference
- VHDL模糊PID控制器模糊推理，推理结果：直接用经验值输出。-Fuzzy PID controller VHDL fuzzy reasoning, reasoning results: the direct use of the experience of the value of output.
stm32_DAC_complecated
- 意法半导体公司推出的stm32 微控制器的片内外设的初始化及其应用程序，应用程序非常精简，在项目中测试过-Stm32 microcontroller chip peripherals STMicroelectronics Introduces initialize its application, the application is very streamlined, tested in the project
2wirelcd
- this a program for 2 wire LCD-this is a program for 2 wire LCD
AirSyncTest_Log
- airsync用与airdebuger的日志对比，setup1-6成功日志参考-about airsync wechat log
sd
- 这里需要用到2G的SD卡，SD卡插上后，会在串口中对数据进行读写,显示0-9-It should be used in 2G SD card after the SD card plugged in the serial read and write data, display 0-9