资源列表
FreqSweep
- 此程序用于arduino板（nano，其他可适当修改引脚），MCU采集信号发生器的波形，然后再输出同等频率的互补方波，主要用于驱动全桥或半桥逆变电路，可作为电力电子电路驱动信号扫频。 信号发生器采集引脚：D4 输出方波引脚：D9和D10(This program is used for Arduino board(nano,also can be modified for other types). MCU collect waveform from signal generator,th
source
- 红外线遥控器的接收程序，可以测出每个遥控器按键的键码值，并能过LCD1602显示出来。(nfrared remote controller receiving program, can measure the key code value of each remote control, and can be displayed over LCD1602.)
app [2]
- Testversion of an Application111
set_ad9522
- 通过C语言配置ad9522寄存器，在DSP上可直接运行，已测试，想学习ad9522的是很好的资料。(Config ad9522 registers by C/C++ language.Running on TI s DSP testing procedures, can be run directly, want to learn ad9522 is a good information.)
IR
- 红外遥控发固定码值程序，可以循环发送码值(IR send and can send always)
cshrc
- so ug bana na kar yaar teri kuttay wali
51ASM
- 51汇编代码参考，包括16位乘法，移位。效率比keil自带的高，占用资源少。(51 asm reference.contain 16 mul 16, shift.higher efficiency than keil.)
stepMode
- 直流电机的PID控制可实现稳定输出角度运行平稳(PID control of DC motor)
ACperiods
- C语言编写，用于交流电检测，可用于干扰较大的交流电网(The C language, used for alternating current detection, can be used to interfere with the larger AC power grid.)
adc2
- stm32 adc 测试，自己测试能用。非常实用（标准库）(Stm32 adc test, own test can be used. Very practical (standard library))
ds18b20
- 温度传感器18b20 设置方式，包括设置、读取(18b20 temperature set)
温度计程序
- 温度检测显示到数码管上，误差较小，注意硬件的相关配置(The temperature detection shows on the digital tube, the error is small, and the related configuration of the hardware is paid attention to.)