资源列表
led_decode
- 用veilog HDL编的七段译码显示电路。自己做的第一个此类程序，编译仿真通过，感觉不错-veilog HDL series with paragraph 107 of the decoder show circuit. I have done the first such procedure, compile through simulation, feeling good
testPTR2000
- ＰＴＲ2000的驱动程序，包里面有两个程序分别是收发程序-PTR2000 driver, the packet contains two procedures are procedures Transceivers
left_right_leds
- 利用Spartan-3 Starter Board实验板上的旋转开关，设计一个通过旋转开关的方向来控制LED灯的依次点亮顺序的实验，并且要求可以循环点亮。
IICBUSC
- 用STC89LE52RC来模拟IIC总线对视频解码芯片SAA7114,多媒体数字信号编码器CS4272等进行初始化，为DSP的图像处理做基础
ICETEK-VC5509-EDU
- TMS320VC5509的dsp中断程序的map文件
code
- Verilog的LED控制器源程序，用于LED显示屏幕的控制。-Verilog source code of the LED controller for the LED display screen control.
lcd-1602
- 基于盛群HT46EU232单片机对lcd1602液晶显示的程序-lcd 1602display based on HT46RU232
Temperature-acquisition
- 采用51单片机进行温度采集的C语言，带一位小数点的精度采集-51 single-chip temperature acquisition of the C language with the acquisition of a decimal point of accuracy
elec_lock
- 验证电子密码锁,具有密码设置，键盘扫描，键盘消抖，和万能密码等功能-Verify electronic locks, have a password set, keyboard, keyboard debounce, and universal passwords and other functions
mqx-small-game
- mqx tower system(K60D100M)的小遊戲 閃燈後必須快速按按鍵 時間內/外 LED燈有不同反應 - The Tower system flashes green LED at 1 sec − You press button1 to stop LED flashing and start a new run of the game − The Tower system waits for a random time to
main
- 对独立按键功能进行设置，前面3个按钮 按下LED灯亮 松开LED灭，同时加上延时效果。-Key features of the independent set, in front of three LED lights release button is pressed LED off, while adding delay effect.
cplca1
- 折页机电子刀控制软件，用于印刷机械控制配套软件是“cplca2.rar"-Knife folding machine electronic control software for the printing machine control software is