资源列表
d02
- 此程序为脉宽测量电路vhdl代码，能够对输入的脉冲信号用10HZ时钟进行计数，输出计数结果。主模块调用显示、计数、控制三个模块实现主体功能
TS18B20
- 温度传感器的ASM源程序,你只要定议数据引脚,就能通过.-temperature sensor ASM source code, as long as you set proposed data pins will be adopted.
68995semaphores
- 在TORNADO下写的基于VXWORKS的多信号量通信的源代码,很不错哦-TORNADO written in under the multi-signal based on the volume of VXWORKS communications source code, oh well
AES_enc_core_tb
- this code discribers testbench for aes algorithm. it is written by .vhdl
IO-Port-Programming
- 8051 source code for understanding I/O port operation and commands
STC_C51
- 单片机舵机控制程序,支持串口通信，I/O控制-Microcontroller servo control procedures, and support for serial communication, I/O control
Lab_LCD
- Building a character LCD interface on Spartan-3E FPGA
JHD13232
- 点阵JHD13232的驱动程序，单片机程序-Lattice JHD13232 drivers, SCM
PIC-18F452-bianmaqi
- PIC 读编码器 模拟串口 PWM调整输出-PIC read analog serial encoder to adjust the output PWM
CRC
- 利用VHDL语言,用FPGA设计一个数据通信中常用的数据检错模块—循环冗余校验CRC模块,选用当前应用最广泛的EDA软件QUARTUS II作为开发平台-Using VHDL, FPGA design of a common data in data communication error detection module- Cyclic Redundancy Check (CRC) module, currently the most widely used EDA software QUAR
TemperatureSystem
- 使用单片机和温度传感器制作数字温度计 1、实时温度采集 2、数字显示 3、显示精度：0.1 4、其它和温度有关的扩展 -Making use of SCM and temperature sensor digital thermometer 1, real-time temperature acquisition 2, digital display 3, display accu
WheelRobot.ino
- 基于arduino控制的二轮直立小车机器人程序-Based on arduino control of two rounds of vertical car robot program