资源列表
max7219的串联编程
- 两片max7219的串联编程 编程语言为汇编语言-two max7219 Series programming language programming language for compilation
msp430 Timer_A uart9600_06
- 利用MSP430的Timer A 模拟UART功能，波特率9600 32kHz ACLK-using MSP430 Timer A simulation function UART, 9600 Baud Rate 32kHz ACLK
PCF8563
- c语言编写的时钟芯片PFC8563源程序
SHT11.rar
- C语言编写的温湿度传感器SHT11与51单片机的接口驱动程序，做毕业设计很辛苦弄好的，网上找不到的哦！,C language SHT11 temperature and humidity sensor with 51 single-chip interface driver, very hard to do graduate design ready, and the Internet can not be found Oh!
SJ1000_Driver
- Xscale下CAN总线控制器SJ1000驱动-Xscale under the CAN bus controller driver SJ1000
MiniHorn
- MiniHorn报警器源码，UL464标准，详细资料联系zhlhailun@yeah.net-MiniHorn alarm source, UL464 standards, detailed information contact zhlhailun@yeah.net
PS2AT89
- 使用1602液晶显示和PS/2键盘的示例-The use of liquid crystal display 1602 and PS/2 keyboard sample
121114141SHT11
- 这个SHT11非常全，含有 SHT11avr程序.c，SHT11程序C51驱动.zip，SHT11程序C51驱动注解.pdf，SHTxx.c，sht故障排除.pdf，SHT焊接要求.pdf，SHT引脚.pdf-This SHT11 very wide, containing SHT11avr procedures. C, SHT11 procedures C51 driver. Zip, SHT11 procedures C51-driven annotation. Pdf, SHTxx.c,
STC89C52RCmotor
- STC89C52RC步进电机控制程序,利用单片机输出脉冲，方向信号，控制驱动器，驱动步进电机。-STC89C52RC stepper motor control program, the use of microcontroller output pulse and direction signals to control the drive and stepper motor.
LCD1602[1].h
- 这是基于单片机的计算器程序，在LCD1602屏上显示输出的结果-This is based on single-chip calculator program, Math functions can be achieved
Infrared-communications
- 红外的接收程序与发送程序，实现远距离红外通信。-Infrared receiving program and sending program to achieve long-range infrared communication.
dabpianji1730
- C语言实现的ISD1730的录放功能，适用于单片机编程，当然也可以给ARM学习者参考-C language implementation of the ISD1730 of playback capabilities for MCU programming, of course, learners can refer to the ARM