资源列表
DSP28_Gpio
- 适合DSP初学者的小程序-DSP28_Gpio.c DSP28_Gpio.c DSP28_Gpio.c
Fir
- 一个关于数字信号处理中FIR算法的c语言源程序，可以通过在TI公司的CCS软件中硬件仿真或软件仿真产生波形-On digital signal processing algorithm in the FIR of the c language source code is available through the TI' s CCS software or hardware simulation software simulation waveforms generated
my_gold
- 基于FPGA的gold码发生器，用VHDL语言编写的源程序。-The gold code generator based on FPGA, VHDL language with the source.
drive
- TCD1300ccd的驱动，是用 Verilog实现的
RTCDS1307
- Real time clock with micro controller
1
- 频率计程序cpld-Frequency counter counting procedures
fft
- DSP code for FFT algorithm
protect_a
- 本程序是关于电力继电保护的A相电流的速断保护程序-This program is a quick break saver power relay A phase current
ade
- 用verilog HDL语言实现一个8位串行乘法器-An 8-bit serial multiplier with Verilog HDL language
46xx_ad_sample
- 该例子使用ht46r47对pb0的电压进行侦测，如果电压超过0.3v Port A 输出FFH,低于0.3v输出00H-This example uses ht46r47 right pb0 voltage detect, if the voltage exceeds 0.3v Port A output FFH, 00H below 0.3v output
NEW AUDIO CODEC DEVELOPMENT CODE BASE
- Hi friends, This consists of a complete system written in Verilog/TCL for VGA DISPLAY OF RESULTS INPUTTED THROUGH AUDIO CODEC AND COMPLETE SYSTEM LEVEL DESIGN ON VERILOG.
config_fuse_dsPIC33FJ128MC510A
- 33FJ128MC510A的熔丝位配置代码，经过加密。下载端口为PCG2-33FJ128MC510A fuse configuration