资源列表
lcddriv
- 2812驱动128*64液晶,把该文件加到工程中，在主函数中初始化液晶既可用了．
STCDaulUart
- STC单片机双串口，串口1,2测试程序，串口2使用独立波特率发生器作为波特率发生器。-SCM STC dual serial, serial 1,2-testing procedures, using serial two independent Baud Rate Generator as the baud rate generator.
subprog
- 单片机C语言,常用的多个功能, 子程序-Singlechip C language, commonly used in a number of functions, subroutines
Cprogram
- 控制步进电机的C语言源代码 c程序设计-Stepper motor control C-language source code c programming
ds18b20
- 单片机的水温控制系统 DS18B20控制 12864显示-Single-chip temperature control system control DS18B20 show 12864
ad
- DSP 2812 AD采样程序-DSP 2812 AD
spimaster
- -- Descr iption : This core implements a SPI master interface. -- Transfer size is 4, 8, 12 or 16 bits. -- The SPI clock is 0 when idle, sampled on -- the rising edge of the SPI clock. -- The SPI clock is derived from the bus clock input
control-the-whistal
- 用for循环语句控制蜂鸣器鸣笛次数的一段程序-Control the number of buzzer whistle for statement
JD273_GM
- 采用8位MCU的燃气点火器的源程序，采用汇编程序编写-8-bit MCU gas ignition source, using assembler programming
STM32_TIMER
- 使用STM32来控制定时器使用操作的源码-Use STM32 to control timer operations Source
gyroscope-stm32
- 惯导 加速度计 陀螺仪程序，STM32测试程序。上传共享，资源共享。-Inertial accelerometer gyroscope program, STM32 test program. Upload and share, resource sharing.
WL012
- 51驱动1602液晶-MCS51 1602DRIVER